AME Intl. 13155 Instrukcja obsługi

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Systemy podnoszenia AME Intl. 13155. AME Intl. 13155 5 stron. 100 ton aluminum cylinder with locking collar

Drukuj stronę

PLEASE READ AND FOLLOW THIS INSTRUCTION BEFORE YOU USE AME International

LOCK NUT CYLINDERS.

Carefully inspect all components for shipping damage, if shipping damage is found. Please notify

carrier at once. The carrier is responsible for any damage resulting from shipment.

1. SAFETY

To avoid personal injury or property damage, please follow all safety precautions.

AME International cannot be responsible for injury or damage resulting from unsafe

and incorrect products use or system operation, or lack of maintenance.

DANGER is only used when your action or lack of action may cause serious injury or even death.

WARNING indicates a potential danger that requires correct action to avoid personal injury.

IMPORTANT indicates correct action to prevent damage or equipment failure.

DANGER



The hydraulic equipment operator must be a qualified operator must have correct training

and work experience with hydraulic equipment. Lack of knowledge in any of these areas can

lead to equipment damage or personal injury.



Carefully inspect cylinder, coupler, hose and hand pump before using hydraulic equipment, if

you find any damage, please contact with your nearest Authorized AME International

Service Center or Sales office. Any damage can cause personal injury when you use the

cylinder.



To avoid personal injury, please do not modify or weld hydraulic equipment without approval

of AME International.



Please never lift a more than the rated capacity of the cylinder, overloading causes

equipment failure and serious personal injury.



The cylinder is a load lifting device, not a load holding device. After the load has been raised

or lowered, it must always be held mechanically, never work under a load supported by a

hydraulic unit.



Keep hands and feet away from cylinder and workplace during operation to avoid personal

injury.



NEVER put unbalanced or off-center loads on cylinders. The incorrect load can result in

equipment failure and serious personal injury.

WARNING



Please wear safety glasses, helmet and other necessary personal protective equipment

when operating hydraulic equipment.



Use cylinder to lift load should have solid lifting surface for correct support. Please select

AME INTERNATIONAL

AME International Operating Manual for 100 Ton Aluminum

Cylinder with Locking Collar

Part Number 13155