Coastal WEATHERPAK MTR Podręcznik użytkownika - Strona 9

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Stacja pogodowa Coastal WEATHERPAK MTR. Coastal WEATHERPAK MTR 20 stron.

Drukuj stronę

Connecting to a Computer with Serial to USB Converter

2-2.3

In the event the computer does not have a USB port, you must employ a "Serial to USB" converter, which is

available at your local computer supply store. Connect the Serial cable to the converter. Follow the directions

provided with the Serial to USB device.

2-2.4

Connecting to a Computer with the Ethernet Port

This method is to be employed only if the Receiver/Display must be connected to a network. Please contact

Coastal Environmental Systems, Inc. for further information.

2-3

TRIPOD AND WEATHERPAK

Assemble the tower in the following manner:

Insert and lock the legs onto the bottom section of the

tower, forming the tower's tripod base.

Align the slot on the WEATHERPAK

on the quick release and push straight in. DO NOT

"screw" the WEATHERPAK

connector. The KamLock provides a precision sealed fit

and may require an extra push to seat the

WEATHERPAK

properly. Once the weather station is

properly seated, press the arms of the clamp down to

assure a tight fit. The battery indicator light (on the

tower junction box) should illuminate when the

WEATHERPAK

is properly seated into the KamLock.

Place the entire unit (upper tower section and



WEATHERPAK

) onto the tripod, engage the twist-lock

and turn clockwise ¼ turn.

The WEATHERPAK

When the WEATHERPAK

KamLock connector, it will stop sampling and shut itself

off.

CHAPTER 3 SYSTEM OPERATION

Once set up, the WEATHERPAK

weather conditions and transmits data to the Receiver/Display

every 30 seconds. (See "Data Line Interpretation" in Section 3-

3.5, for additional information.)

The Receiver/Display takes approximately 20-30 seconds to

complete a boot-up routine. When this process is complete, it is ready to accept the first transmission from the

WEATHERPAK

. The data may now be viewed on the display or viewed and archived using Coastal Environmental

Systems' optional INTERCEPT™ software. Plume modeling software requires five minutes of data before a valid plume

can be presented,

CONFIGURING THE DISPLAY

3-1

During the boot-up process two touch screen buttons will appear labeled Configure and Skip Configuration.

When selected, the Configure button opens a series of screens which allow the operator to select from several

data display configuration choices. Once these selections have been made (typically the first time you boot-up

your new system), the values are stored in memory. It is not necessary to configure the system every time it is

used. The configuration screen will time-out in approximately five seconds, or you can touch the Skip

Configuration button to proceed. Configuration choices are:

P/N: 0302-140-001 Rev. D

SET UP



with the guide pin



onto the KamLock



is now running and sampling data.



is removed from the



automatically begins sampling

WEATHERPAK

User's Manual

Figure 3 – Tower Set-up

MTR