aero pure AP80-QVL Instrukcja instalacji - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Wentylator aero pure AP80-QVL. aero pure AP80-QVL 4 stron. Recessed fan light
Również dla aero pure AP80-QVL: Instrukcja instalacji (13 strony)
Drukuj stronę
CONNECT ELECTRICAL WIRING
Run 120 Volts AC house wiring to the fan. Use only UL-approved connectors (not included) to attach the house wiring to the
wiring plate. Refer to the wiring diagram, and connect the wires as shown.
AP80-QVL
AP80H-QVL
FINISH CEILING WORK
1. A round ceiling hole 6 1/2 inches (165mm) diameter should be cut.
Seal any gap between the hole in the drywall and the fan with sealant .
2. Install the the compact florescent bulb or LED bulb. Bulb not included.
3.The bulb housing can adjust up or down to accommodate different
bulbs.Unit is qualified with use of GU24 adaptor and use of a GU24 bulb.
REPLACEMENT INSTA LLATION
1. Remove the trim ring by detaching the springs.
2. Remove the screws as shown in the right.
3. Remove the lamp base.
4. Pull the duct system, so that you can see the blower system.
REPLACEMENT INSTALLATION
5. Remove the screws as shown in the right.
6. Remove the blower system from of the housing.
7. Replace the broken parts.
READ AND SAVE THESE INSTRUCTIONS
Installer: Leave this manual with the homeowner
3
AP80-QVL, AP80H-QVL