aero-naut Princess Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zabawka aero-naut Princess. aero-naut Princess 17 stron. 3081/00

Glue the bow doublers 56 to the deck,

leaving a gap about 2 mm wide to the

outside edge of the deck. Round off the

edges slightly.

Glue the cockpit front panel 58 in place

between parts 37 and to the floor 39. Pull

the side panels 37 together using adhesive

tape before gluing the joints.

Glue the deck covers 59 and 60 to parts 40

and 42.

Glue the instrument housing 62 in the

instrument panel 61. Cut out the printed

instruments 63, give them a coat of

waterproof lacquer and glue them to the

reverse of the instrument housing 62.

Fold the cockpit wall padding 64 along the

longitudinal centreline and glue the mating

faces together. Glue these parts to the

cockpit wall, flush at the top, and cut them

away at the front as shown.

Glue the sleeve 79 in the instrument panel

61 and to part 58; the sleeve 79 should

project out of the instrument panel 61 by 30

mm, in the direction of the seat. Glue the

shaft 80 in the steering wheel 81. When the

glue has set hard, slide the shaft and

steering wheel into the tube 79.