Aktakom ASE-1119 Podręcznik użytkownika - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Pistolet lutowniczy Aktakom ASE-1119. Aktakom ASE-1119 4 stron.

On ﬁrst use the soldering iron may produce smoke, this is just grease

used in manufacturing burning off, it is not harmful to the product or

user.

1. Safety Instructions

The construction of the soldering station meets Protection Level I.

Ensure the earth conductor is not disconnected and the product is

only connected to earthed sockets.

Keep electrical appliances and accessories away from children! They

are not toys.

Never use the product immediately aﬂer it has been brought in from

the cold into a warm room.

Condensation might destroy your device; Wait until the product is at

room temperature before use.

Never touch the appliance with damp or wet hands, there is the risk of

a dangerous electrical shock.

Make sure to have sufficient ventilation while soldering, solder or

solder flux can be harmful.

Wash your hands thoroughly after working with solder containing lead,

do not let solder containing lead cross your lips; do not eat during the

work.

The power cables (power cable and cable to soldering iron) have to

be protected against heat and sharp edges.

Wear appropriate protective clothing and safety goggles while

soldering.

Do not touch any other area but the handle when the soldering iron is

working. It is very hot!

Do not leave children alone in the presence of the soldering iron.

Soldering must be done on non-combustible surfaces. Make sure any

material in the vicinity can not be damaged by the heat.

When the device can no longer be operated safely, disconnect it

immediately and secure it against being operated unintentionally.

It can be assumed that safe operation is no longer possible if:

• the device exhibits visible damage

• the device no longer works

• it has been stored for a long time under unfavorable conditions

• the device was exposed to extraordinary stress caused by

transport.

2. Operation

1. Unpack the soldering station and check all parts. Damaged parts

may not be put in to operation.