COASTLINE Windlass Instrukcja instalacji i obsługi - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Pilot zdalnego sterowania COASTLINE Windlass. COASTLINE Windlass 12 stron. Radio remote control
Drukuj stronęSpecial Functions
Programming a Spare Remote
Spare Remotes can be ordered and are factory programmed with the ID of the
Receiver. If a Remote has not been preprogrammed it can be programmed in-
situ on the boat.
The Remote must be in 'sleep' mode i.e. after 10 mins of inactivity.
Switch off power to the Receiver for 5 seconds and then switch it on again.
You now have 1 minute in which to program the Remote.
Press and hold both buttons on the Remote for 20 seconds (30 secs max).
After 2 seconds the green led will light up, after 20 seconds the green led will
go off and the red led will go on.
Release both buttons. The Remote is now in Program Mode.
The red led will go off once the Remote has been programmed with the
Receiver's ID.
The 'UP' and 'DOWN' leds on the Receiver will both go on briefly before going
off and the Remote will then go into 'sleep' mode.
Reverting to Factory programmed ID
If for any reason it is necessary to revert to the original factory programmed ID
then the following procedure should be followed:
Remote must be in 'sleep' mode i.e. after 10 mins of inactivity.
Press and hold both buttons on the Remote for 40 seconds (60 secs max).
After 2 seconds the green led will light up, after 20 seconds the green led will
go off and the red led will go on. After 40 seconds the red led will go off.
The green and red leds will then blink alternately.
Release both buttons and the remote will then go into 'sleep' mode.
Forced 'Sleep' mode
The Remote can be forced to go to 'sleep' (as alternative to 10 mins of
inactivity).
Press and hold both buttons for 60 seconds. After 60 seconds both red and
green leds will come on.
Release both buttons and the Remote will enter 'sleep' mode.