AeroBed R2110 AU / RDV Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Pompa wodna AeroBed R2110 AU / RDV. AeroBed R2110 AU / RDV 8 stron.

• Pump is not intended for continuous use. Pump may stop

working or overheat if it is used for extended periods of time.

Do not use pump continuously for more than 5 minutes.

Once pump is overheat, let it rest for 30 minutes for restart.

• Do not attempt to disassemble, repair, or service the pump.

No serviceable parts are contained inside. Contact Consumer

Service Department for repair or servicing information.

• Avoid splashing the pump with water.

• Never overinflate an inflatable item.

• Unplug product when not in use.

• Do not block air intake during operation; this could damage

the motor.

• Always monitor the pump during use.

SERVICING OF DOUBLE-INSULATED PRODUCTS

In a double-insulated product, two systems of insulation are provided instead of

grounding. No grounding means is provided on a double-insulated product, nor is a

means for grounding to be added to the product. Servicing a double-insulated product

requires extreme care and knowledge of the system, and is to be done only by qualified

service personnel. Replacement parts for a double-insulated product must be identical to

the parts they replace.

IMPORTANT: TIME TO FULLY INFLATE IS APPROXIMATELY 4

MINUTES. TO AVOID OVERHEATING AND PUMP DAMAGE, DO

NOT LET PUMP RUN CONTINUOUSLY FOR MORE THAN

5 MINUTES.

IMPORTANT: THE FIRMNESS OF YOUR AIRBED MAY

DECREASE AFTER YOU INITIALLY INFLATE IT. YOUR AIRBED

IS NOT LEAKING. THIS IS NORMAL AND IS CAUSED BY THE

MATERIAL STRETCHING AFTER THE AIRBED IS INFLATED.

ADD AIR TO MAINTAIN YOUR DESIRED FIRMNESS.

NOTE: BED MUST BE AT ROOM TEMPERATURE PRIOR

TO INFLATING OR IT MAY CAUSE AIR LEAKS. PRESSURE

CAN VARY DEPENDING ON ROOM TEMPERATURE AND

CONSUMER WEIGHT.

1. Place your rolled-up bed on the floor free of obstructions or sharp objects.

2. Make certain the Quick Release Valve is closed. Bed should be stored with valve in

the closed and latched position. If the Quick Release Valve is open, close it by using 2

thumbs to push cover and snap into valve. Be careful to avoid pushing valve cover to

the right or left as it snaps into the valve opening.

3. Remove AC plug and cord from plastic bag and shrink wrap.

INFLATION