BOBPERRY AUDIO ATC 2 Podręcznik - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik dla Kontroler BOBPERRY AUDIO ATC 2. BOBPERRY AUDIO ATC 2 8 stron. Automatic talkback controller

MASTER BUS

To further facilitate communication with a musician during a recording session, you can use

MASTER BUS mode as follows:

• Load a Bob Perry ATC 2 into one of your DAW's Master insert/FX slots.

• Enable MASTER BUS in this ATC 2 instance.

In the main interface window of this ATC 2 window, controls for DIM LEVEL and

LISTEN VOL will appear.

• Set a desired DIM LEVEL.

Now, each time you use the TALK button, or trigger it via MIDI, ATC 2 will dim the

master mix by the set amount.

• (optional) Route a live listenback microphone input signal to the side chain of this ATC 2

instance.

This will give you the possibility to hear the musician talking while the rest of your

recording is dimmed. Adjust the volume of the listenback signal with LISTEN VOL.

TALK buttons of all Bob Perry ATC 2 instances are synchronised, so pressing TALK on a non-

master bus ATC 2 will also trigger the dimming of the master bus mode-enabled ATC 2.

Hint: If you want to use MIDI TRIGGER, you only need to set up MIDI TRIGGER in one instance

of Bob Perry ATC, as it will always trigger all instances simultaneously.

MANUAL MODE

When MANUAL MODE is enabled, ATC 2 will remain muted even when playback or recording

is stopped. You have to then always press TALK when you want to speak to the musician.

PREFERENCES

SAVE WINDOW SIZE

Saves the window size of the plug-in. When enabled, all

Bob Perry ATC 2 instances will open with the same (last used) window size.

SAVE PREFS GLOBALLY

When enabled, the following settings will be stored globally:

LO CUT FILTER, SAVE WINDOW SIZE, your window size

To restore Global Preferences to their default settings, double-click on

RESET PREFERENCES.

VST is a software and trademark of Steinberg Media Technologies GmbH.

Bob Perry ATC – Manual – Page 5/8

011321160820