BOC Smoothcut Plasma 25 Torch Instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przecinarka plazmowa BOC Smoothcut Plasma 25 Torch. BOC Smoothcut Plasma 25 Torch 12 stron. Boc smoothcut plasma 25 torch plasma cutter
Drukuj stronę
4.0 Torch assembly
1
2
3
4
4.1
Fitting the consumables
1
1
Place the electrode
into the torch head
2
2
Place the gas
distributor
over the electrode
3
3
Place the tip
onto the g
as distributor
4
4
Screw the shield cup
over the parts and hand tighten onto the torch
head. Do not over tighten the shield cup
IMPORTANT
As a safety feature of the torch, the cutting torch will not operate
unless the shield cup is fi tted properly.
4.2 Fitting the torch to the power source
1
Connect the air/electrical connection
to the terminal indicated as
not overtighten.
2
IMPORTANT SAFETY NOTICE
A
Push the rubber boot
over the terminal and ensure that it is
completely covered.
C
3
Connect the contactor/trigger
plug to the terminal indicated as
4
Fit the work return lead and clamp to the terminal indicated as
.
B
by fi xing the hexagon nut
. Tighten the nut fi rmly but do
switch cable connector by fi tting the
.
BOC Smoothcut Plasma 25 Torch Operating manual
A
B
C
4.3 Selecting the correct air
pressure and fl ow rate
Compressed air from compressed air lines is often contaminated with
moisture and oil residue. Contaminants such as these shorten the life of
the consumable torch parts. It is therefore recommended that an inline
fi lter drying system be fi tted to all air delivery lines.
When air is supplied from a portable air compressor, it is important to
ensure that the compressor has adequate pressure and airfl ow rate
capacity such as the BOC 14 (and upwards) air compressors.
Air supply requirements for BOC Smoothcut Plasma 25 Torch
Pressure
Draw-off rate
NOTE
The Smoothcut Plasma 25 torch is a contact start torch. Therefore the
cutting tip must be in contact with the work piece before the torch
switch is operated.
The contact start mechanism means that stand-off guides cannot be
used with the Smoothcut Plasma 25 torch.
Rubber boot fi tted to the end of the
Smoothcut Plasma 25 torch to cover the
Air/Electrical outlet.
A
CAUTION
This is a safety device and must
be fitted over the air/electrical
connection prior to use
Air/electrical connection nut
B
(inside rubber boot).
Contactor/trigger switch cable
C
connector
4.8–5.0 bar
100 L/min
7