Air cat 6700-6-336 Instrukcja obsługi, lista części i gwarancja - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi, lista części i gwarancja dla Narzędzie pneumatyczne Air cat 6700-6-336. Air cat 6700-6-336 4 stron. 6 inch orbital palm sander

Drukuj stronę

Important Warnings - Sanders & Polishers

1. Eye protection, safety gloves and safety aprons must always we worn when operating a sander or

polisher.

2. Never adjust the sander or polisher or change the backing pad, sanding disc, sanding belt or

polishing bonnet unless the air supply and air hose is disconnected from the tool

3. Only use backing pads and polishing backing pads that have a rated speed then same as the sander

or polisher or higher.

4. Never attempt to modify or adapt a sander or polisher for use with a grinding wheel or cut-off wheel

or wire brush.

5. Only personnel trained in the correct methods to change pads, sanding discs, sanding belts and

polishing bonnets should conduct these operations.

SPECIFICATIONS

Model No.

Pad Size

(in)

6700-6-336

Air Supply

Tools of this class operate on a wide range of air pressure. It is recommended that air pressure of these tools measures 90 PSI at the tool while running free. Higher

pressure and unclean air will shorten the tool's life because of faster wear and may create a hazardous condition and void the warranty. Water in the air line will

cause damage to the tool. Drain the air tank daily. Clean the air inlet lter screen on at least a weekly schedule. The recommended hookup procedure can be viewed

in the illustration below. The air inlet, used for connecting air supply, has standard 1/4" NPT American Thread. Line pressure should be increased to compensate for

unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8" I.D. and ttings should have the same inside dimensions.

Orbit

Pad Type

Free

(in)

Speed

(RPM)

3/16

Hook & Loop

11,000

Weight

Length w/

Width w/

(lbs)

Pad Fitted

(in)

2.0

6.8

6.0

Height w/

Noise Level

Vibration

Pad Fitted

d(B)A

m/sec2

(in)

4.3

0.8

Average

Air Inlet

Air (CFM)

(in.) NPT/

BSP

1.6

1/4