DOMPEL ESTETICA Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wózek zewnętrzny DOMPEL ESTETICA. DOMPEL ESTETICA 6 stron. Trolley

Drukuj stronę

ENGLISH

LOCATION OF INSTALLATION

Install your Dompel product in a level place with no grooves or splices,

preventing rocking and vibration. The location must be airy and it must not

allow straight sunlight and it must be away from sources of heat (stoves,

ovens, etc.) and ﬂammable products. Do not install your product outdoors.

CLEANING AND MAINTENANCE

Do not use metal spatulas, brushes and cleaning agents such as alcohol, acetone, kerosene, gasoline, bleach,

thinner, solvents, varsol, vinegar or other chemicals or abrasives such as sandpaper or steel brushes.

To easily clean it, use a solution of warm water with a neutral soap and then wipe dry carefully. If chemical products

reach the upholstery, clean as soon as possible, preventing the products from staining or drying the fabric. The

plastic parts can not be washed with boiling water. Chromed metal components can be cleaned with a soft, dry

ﬂannel, and silicone-based automotive wax can be used to increase gloss and durability, in this case perform the

task following the wax manufacturer's instructions. Perform periodic cleaning, accumulated dust aﬀects the beauty

of the product making it di翿 cult to clean the product.

INSTALLATION AND ASSEMBLY

Remove all components from the carton. The 4 casters are in a plastic bag inside the carton. The assembly

of this trolley is totally manual and requires no tools.

IMPORTANT

This trolley allows 3 modes of shelf layout. Choose your favorite by observing the assembly position

of the long extender (F) in the conﬁgurations: (X) long extender assembled on the lower shelf; (Y)

long extender assembled on the middle shelf; (Z) long extender assembled below the top.

Support the shelf (A) on a ﬂat base and manually

ﬁt the 4 caster supports (D) on the bottom of the

shelf.

Merely illustrative images.

Products may suﬀer changes in its components without prior warning. If any questions, contact Dompel.

Assemble the

ﬁrst 4 extenders

- short or long

(E or F) on the

top of the shelf

(A). Repeat this

process for the

next 4 modules.

Manually ﬁt the 04 casters (C) into the caster

supports (D). Make sure they are well ﬁtted and

aligned when resting on the ﬂoor.

Finish the assembly by ﬁtting the last 4

extenders (E or F) and the top (B).

Important! To ensure safety and prevent

damage to the product, distribute the

weight evenly over the support areas and

avoid long journeys on uneven ground with

maximum load.

SECURITY

Avoid accidents. After

unpacking the product, keep

all the pack material out of

children's reach.

Fit the shelf

(A) into the

extenders (E or

F). Repeat this

process in the

next module.