Domus Viento-48 Instrukcja instalacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Wentylator Domus Viento-48. Domus Viento-48 17 stron.

Step 1

Secure the mounting bracket to the ceiling using expansion bolts and nuts. Use appropriate anchors for the ceiling

material.

Expansion Bolts and Nuts

NOTES:

•

If installing on raked ceiling, make sure the lug in the mounting bracket is on the high side towards the highest point

of the roof. If lug is on the low side, the fan will not hang properly.

•

Plasterboard cannot hold the weight of a ceiling fan alone. A supporting beam such as timber between two ceiling

joists or beams is necessary.

•

A 2.3M clearance is recommended from the floor to the blades.

Step 2

A) Lift cover on top of ceiling fan motor and loosen screws until they are out of sight from downrod holder. Remove the

safety bolt and pin from coupling.

B) Install canopy over the downrod. Insert wires and safety cord through downrod and insert into the top of fan

coupling. Align the holes in downrod to match holes in downrod holder.

C) Insert safety bolt and secure with washers and cotter pin. Tighten the two screws firmly to ensure the most stable

installation.

WARNING: Failure to tighten downrod as described above could result in the loosening or falling of the fan.

Expansion Bolts and Nuts

Note: The Ceiling Fan must be installed by a licensed Electrician. Ensure the power is switched off before fitting this ceiling fan.

For any questions, please call Domus® on (02) 9554 9600, Monday to Friday 9am – 5pm EST.

Concrete Ceiling

Insert The Safety

Bolt Into The Hole

Expansion Bolts and Nuts

Set Screw

Concrete Ceiling

Mounting Bracket

29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia

Phone: 02 9554 9600

17˚

Hangsure Mounting

Suitable for raked ceilings with a maximum angle of 20O.

Concrete Ceiling

Insert The Safety

Bolt Into The Hole

Set Screw

Fax: 02 9554 9433

www.domuslighting.com

Installation Manual