Domus 25012 Instrukcja instalacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt oświetleniowy Domus 25012. Domus 25012 4 stron.

Installation

1. Installation by a licensed electrician and according to IEC wiring Regulation.

2. Switch power off at the meter box and ensure that there is no power to the lamp.

3. Unscrew the Fixing Cover Screws then remove the cover.

4. Remove the Cable Anchorage and Terminal Block.

5. Use the plastic back box to mark the position of screw holes onto mounting surface. Drill the wall to

depth of about 4 cm and fit the wall plugs (supplied). Care should be taken to avoid drilling or screwing

into concealed electrical wiring.

6. Connecting the Power Cable to the Terminal Block, ensure the cable must penetrate through the Cable

Gasket.

7. Affix the back box to the mounting surface with Mounting Wall Screws (supplied).

8. Re-fit the Terminal Block and Cable Anchorage.

9. Re-fit the cover.

Fixing Cover Screws(x2)

Yellow/Green(Power Cable)

Lamp Body

Brown(Lamp Wire)

Blue(Lamp Wire)

Blue(Power Cable)

Brown(Power Cable)

29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia

Phone: 02 9554 9600

Terminal Block

Gasket

Fax: 02 9554 9433

www.domuslighting.com

Installation Manual

Mounting Wall Screws (2pcs)

Power Cable

Plastic plugs

Wall Mounting Cover

Rubber Stopper

Cable Anchorage

Screws (M3--2pcs)

Black(PIR Wire)

Blue

Yellow/Green(Lamp Wire)

Blue(PIR Wire)

Brown(PIR Wire)