DOMUS LINE 103377492 Instrukcja instalacji - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Oprawa oświetleniowa DOMUS LINE 103377492. DOMUS LINE 103377492 17 stron.

INSTALLATION MANUAL

Connect the DOTTI IR input cable (IN) to the adapter cable (G)

and then to one of the free slots on the distributor (I) on the

power supply secondary cable; then connect the connector (L)

on the DOTTI IR output cable (OUT) to connector (M) on the

Micro12 distributor cable (H).

OPERATION:

- If DOTTI IR is set to "ON/OFF" + Dimmer switch mode, the

device switches the connected lights on and off simply by

moving the hand near the sensor or holding the hand over the

sensor to vary the brightness (Dimmer).

- If DOTTI IR is set to limit switch mode the connected lights will

be switched off when an object (such as a cupboard door)

moves into the radius of action of the device (Fig.3). Vice versa,

the connected lights are switched on when there is no object

within its radius of action.

ATTENTION

- If the external wires on the device are damaged the device

must be replaced.

- Connect DOTTI IR only to a safe power supply with 12Vdc or

24Vdc stabilised voltage, and never connect it to other

electronic switches or DIMMERS of any kind.

It is not advised to connect DOTTI IR to a traditional domestic

mechanical switch.

- DOTTI IR must not be installed near heat sources or

electromagnetic fields which could alter or compromise its

operation.

The warranty on the device is valid only if powered by a power

supply provided by DOMUS Line. The warranty's general terms

and conditions for this device are available at