American Standard Retrospect 7812.295 Instrukcja montażu/instalacji - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja montażu/instalacji dla Wyposażenie wnętrz American Standard Retrospect 7812.295. American Standard Retrospect 7812.295 4 stron. Retrospect console table
Drukuj stronę
1
#1
Run the two front leg sub-assemblies (Item #1) through the
two front holes of the towel bar (Item #2). Do the same with
the two rear leg assemblies (Item #3). Adjust the hex nut at
the end of each rear leg such that 5/8" of thread is exposed.
Turn the unit upside down.
3
Place a bottom leg tube (Item #5) over each threaded rod
such that the closed end of each is nearer to you. Thread one
hex nut from the kit (Item #6) onto each rod. Lay the unit
down and tighten each of the four legs firmly. Maintain the
5/8" of exposed thread at the top end of the rear legs. Once
again, set the unit upside down.
1
Note: If replacing an existing sink be certain to shut
off water supply before removing old sink. If installing
in a new bathroom follow rough-in diagram to locate
rough supply, waste lines.
Provide suitable reinforcement behind finished wall for
sink hanger screws. For an installed sink height of
36", center the reinforcement 29" above the floor.
#3
#2
#6
#5
SINK AND CONSOLE TABLE LEG INSTALLATION
2
Place a middle leg tube
(Item #4) over each
threaded rod. Identify the
shelf support pins at the
inner corners of the Shelf
Support (Item #5). Guide
each threaded rod through
the corners of the shelf
support so that these
support pins are nearer to
you.
#4
4
#7
Thread one decorative foot (Item #7) onto the end of each rod
until the leading end of the rod is recessed with the foot to a
depth of 1/4". Set the unit upright and thread one leveling
trumpet (Item #8) on the top of the rear legs.
Note: To prevent breakage, put the rectangular glass
shelf in place only after the sink and console legs are
completely assembled and the sink has been bolted to
the wall.
Upon completion of console assembly, follow installation
procedure below.
C/L of 2 x 8
Support
and Bracket
Finished
Floor
- 2 -
30-3/4"
7 3 0 7 5 7 - 1 0 0 REV. B
#5
#8