DOMUS LINE LINEO TDM Instrukcja instalacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Latarnia DOMUS LINE LINEO TDM. DOMUS LINE LINEO TDM 15 stron.

Drukuj stronę

INSTALLATION MANUAL

WARNING:

Safety is guaranteed if these instructions are

followed and therefore they must be kept.

Installation may require the involvement of qualified

personnel. Before proceeding with installation of the

device ensure that the environmental conditions are

in compliance with and suitable for the product

characteristics. Before any operation on the device

disconnect mains power.

CONFIGURATION:

Instructions for installation and use contained in this

manual are valid for several configurations of the

LINEO device, for which there are differences.

LINEO TDM (touch sensor) model refers to the

configuration of the device that includes a dimmable

electronic switch.

LINEO model refers to the configuration of the

device that does not incorporate any switch or

sensor.

INSTALLATION:

- Fasten the bracket (A), using the screws in the pack

(B), on the installation surface in the position

wanted. To install the fixture correctly, fasten the

bracket (A) so it is against the wall and at right angles

to it (fig. 1-2).

- Connect the spotlights to the adaptor and using the

extensions provided in the pack (D) following the

wiring diagram:

- SLAVE: (fig.3) (without switch)

- TDM: (fig.4) (TOUCH SENSOR master)

- Connect the feeder plug (E) to an AC outlet 230V

50/60Hz.

- Connect the device power cable to an appropriate

(check plate data printed on the product label) safe

power supply with stabilized voltage (not included)

with power 10% higher than the total load.

- If more than one device must be connected to the

power supply ensure that the total sum of the power

absorbed by the devices (check the plate data shown

on the product label) does not exceed the maximum

power permitted by the Converter.

OPERATION LINEO TDM:

LINEO TDM has a built-in electronic touch switch

that can switch the device on and off, and adjust its

brightness.

To switch the device on and off, simply touch the TD

sensor briefly.

Touch it for longer to increase or decrease the

luminosity.

The whole device flashes briefly to indicate that it

has reached the maximum brightness.

The luminosity level obtained will be saved until the

next adjustment.