Air Cleaning Equipment Horizon Titan XG90 Instrukcja instalacji i obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Osuszacz powietrza Air Cleaning Equipment Horizon Titan XG90. Air Cleaning Equipment Horizon Titan XG90 13 stron.

Drukuj stronę

WARNING:

Do not install your dehumidiﬁer in a corrosive environment. Some liquid va-

por barriers dry via "solvent evaporation". Always make sure that barrier is completely dry

and area is throughly ventilated before installing dehumidiﬁer.

Step #1: Place dehumidiﬁer on a level surface.

If the unit is handled in such a manner that the compressor did not remain in the up-

right position, it is necessary to place on a level surface and wait a minimum of 2 hours be-

fore turning the unit "on"

NOTE: XG90 Dehumidiﬁers can't sit directly on ﬂoor unless the unit is feeding directly

into a sump pump next to it. Elevation is required to allow gravity ﬂow of condensate water

drain.

Step #2: Set Up Drain Line

The drain line should be routed to a suitable drain on the outside. It must ﬂow down

to a drain without any loops, dips, or valleys.

Recommended Drain Option-Transition to PVC Pipe

1. Cut a piece of 3/4" OD PVC that is approx. 6" long.

2. Insert PVC into a 3/4" elbow, then attach to a 3/4" OD length of PVC to drain.

(Note: Keep the length of PVC drain pipe to a minimum)

3. Insert the open end of the tubing into the 3/4" pipe so that it does not extend into

the elbow ﬁtting. For proper ﬂow, a minimum downward slope of 1" per 10' run is re-

quired. (Note: If a proper downward angle is not possible, then it is recommended to

use a Titan XP90 which includes an integrated condensate pump or utilize an exter-

nal condensate pump).

4. Support the PVC tubing so that it maintains a smooth downward ﬂow to drain.

5. Always test the drain before leaving installation area.

Step #3: Plug unit into 15 amp grounded circuit.