Da-Lite ADVANTAGE ELECTROL Instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Ekran projekcyjny Da-Lite ADVANTAGE ELECTROL. Da-Lite ADVANTAGE ELECTROL 12 stron. Tensioned large
Również dla Da-Lite ADVANTAGE ELECTROL: Instrukcja obsługi (12 strony), Podręcznik instalatora (2 strony), Instrukcja obsługi (4 strony), Instrukcja obsługi (12 strony), Instrukcja obsługi (16 strony)
Drukuj stronę
ADVANTAGE
ELECTROL
®
120V WIRING DIAGRAM FOR
STANDARD WALL SWITCH
JUNCTION BOX
LOCATED IN
LEFT ENDCAP
NOTE: A SINGLE SWITCH CANNOT BE
USED TO OPERATE MORE THAN
ONE SCREEN. CONTACT THE
FACTORY FOR FURTHER
INFORMATION.
SPDT SWITCH WITH
CENTER OFF
UP
OFF
DOWN
THIS SWITCH CAN NOT
BE USED WITH LVC.
120V WIRING DIAGRAM WITH
OPTIONAL BUILT-IN VIDEO
PROJECTOR INTERFACE
CAUTION: THE PROJECTOR MUST BE TURNED OFF BEFORE CONNECTING THE TRIGGER
WIRES TO THE PROJECTOR. FAILURE TO DO SO MAY DAMAGE THE CONTROLLER.
Use 2-conductor 20-24 gauge wire to extend the low voltage connection from
the projector's 5 or 12-volt screen trigger output to the length required to reach
the VPI. When extending the low voltage connection from the projector's screen
trigger output polarity does not matter. The red and black wires from the VPI are
interchangeable.
IMPORTANT NOTE:
The wall switch is REQUIRED to make any limit switch adjustments,
EVEN if a third party control system is used. Therefore, it is advised to
wire the switch or provide a 3-conductor connection that is accessible.
INSTALLATION FOR 120V SCREENS
®
AC (COMMON)
BLACK
AC HOT 120VAC 60HZ 1 AMP
BLACK/YELLOW
RED
FRONT OF
WALL SWITCH
WHITE
RED
BLACK
GREEN
LED
RJ-22
UP LIMIT
INPUTS
TACTILE
BUTTON
RJ-22
JACK
U P
S T O
P
DOWN
LIMIT
D O W
N
TACTILE
BUTTON
BACK OF
WALL SWITCH
BLACK
RED
5/12 VOLT SCREEN
TRIGGER ON PROJECTOR
3
MOTOR
RJ-22 JACK
RJ-22 OUTPUT
DRY CONTACTS
RJ-45
JACK
DATA
CABLE
RJ-45
RECEPTACLE
POWER
WIRE
VPI TRIGGER
GREEN (GROUND)
MODULE
BLACK (HOT)
GROUND–MUST BE CONNECTED
WHITE (COMMON)
TO BUILDING GROUND
POWER INPUT 120VAC / 60HZ
FIGURE 3
FIGURE 4