Da-Lite LARGE ADVANTAGE DELUXE ELECTROL Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Ekran projekcyjny Da-Lite LARGE ADVANTAGE DELUXE ELECTROL. Da-Lite LARGE ADVANTAGE DELUXE ELECTROL 13 stron. Automatic electric projection screen
Również dla Da-Lite LARGE ADVANTAGE DELUXE ELECTROL: Instrukcja obsługi (8 strony), Dane techniczne (2 strony), Instrukcja obsługi (10 strony)
Drukuj stronę
Screen And Roller Assembly Installation
If your screen was shipped with the motor and roller already installed proceed to step 7.
1.
Remove four bolts from ends of door assembly (2 bolts on
each end) (Fig. 2). This will allow the door assembly to drop
open for access to case. For larger sizes, you will also need
to remove the door support screws.
2.
Carefully unpack screen and roller assembly. Leave packing
paper on the roller.
3.
Remove the square peg bracket from the motor end of the
roller assembly.
4.
Remove the safety clip from the motor attachement bracket
located in the motor end of the screen housing.
5.
Place the roller assembly into the case with the motor on the
left side. The limit switches should be facing down. Line up
the head of the motor with the motor attachment bracket.
6.
Loosen four bolts that secure pin end mounting bracket into
housing. Lift pin end of roller into position and slide the
bracket into the roller pin. Tighten all four bolts.
7.
Complete electrical hook-up by snapping motor 1/3 wire
connectors into case connectors.
Bolts
Figure 2
6
Door Support Screws
(Not All Sizes)
Access
Door
8.
Return to motor end and insert safety clip over casting
bracket to secure motor end.
CAUTION! Do not cut tape on fabric with a knife or any
sharp tool. Remove by hand.
ATTENTION! Ne coupez pas le ruban adhésif sur la toile
avec un couteau ou un outil tranchant. Retirez à la main.
9.
Carefully remove tape strips securing picture surface around
roller. Slat should move freely (Fig. 3). (Only if the roller
assembly is pre installed.)
10. Test installation by operating the screen several times. Be
prepared to stop the screen. The door assembly will not
close until the wall switch is placed in the up position and
when the screen motor stops at its limit switch in the up
direction.
NOTE: Unit duty cycle is 1 minute on, 3 minutes off.
NOTE: Excessive continuous operation may cause the motor
to overheat. If this happens the motor will shut off until it
cools to a normal operating temperature.
11. Close door assembly and replace four bolts at ends of door
(2 bolts on each end) (Fig. 2).
Dual Motor LVC
Control Box
Screen Motor
Limit Switches
Screen Motor
Door Motor
Limit Switches
Figure 3`
Access Door
Assembly
Door Motor