SCREEN ADJUSTMENT FOR 220/240V SCREENS WITHOUT A BUILT-IN LOW VOLTAGE CONTROL
Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly
adjusted at DA-LITE. Should it be necessary to adjust for more or less picture drop (viewing area), proceed in the
following manner:
NOTE: Use a screwdriver or allen wrench to make adjustments.
SETTING THE DOWN LIMIT POSITION
TO REDUCE SCREEN DROP:
Turn the white limit switch screw clockwise to decrease the amount of screen drop. Run the screen down to test
the stop position. If the screen drops too far, raise the screen about one foot and adjust the limit switch again.
Repeat until the desired position is set.
TO INCREASE SCREEN DROP:
Turn the white limit switch screw counterclockwise to increase the amount of screen drop. Run the screen down
to test the stop position. If the screen does not drop enough, raise the screen about one foot and adjust the limit
switch again. Repeat until the desired position is set. Do not adjust for more drop than what was ordered. At least
1-1/2 wraps of fabric must remain on the roller.
SETTING THE UP LIMIT POSITION
▲
!
CAUTION: Do not allow the slat bar to wrap over the top of the roller when the screen is rolling into the case. The screen could
be damaged.
SCREEN TRAVELS INTO CASE TOO FAR:
Turn the red limit switch screw clockwise to decrease the amount of travel. Run the screen up to test the stop
position. If the screen does not stop properly, lower the screen about one foot and turn the limit switch again.
Repeat until the desired position is set.
SCREEN DOES NOT TRAVEL FAR ENOUGH INTO CASE:
Turn the red limit switch screw counterclockwise to increase the amount of up travel. Run the screen up to test the
stop position. If more travel is desired, lower the screen about one foot and adjust the limit switch again. Repeat
until the desired position is set.
COSMOPOLITAN
®
ELECTROL
220 / 240V
WIRING DIAGRAM
NOTE: A single switch cannot be used to operate more than
®
INSTALLATION
TO JUNCTION BOX, MOUNTED IN
SCREEN CASE, IN WHICH INTERNAL
WIRING TERMINATES IN BLUE,
BROWN AND BLACK LEADS
UP
BROWN /YELLOW
OFF
BROWN AC HOT
ROCKER
SWITCH
BLUE AC COMMON
DOWN
220/240 V. AC 50 HZ.
2 AMP MAX.
REAR VIEW OF DPDT,
WITH CENTER OFF.
BLUE JUMPER WIRE
one screen. Contact the factory for further information.
WIRING ENCLOSURE COVER
UP RED
LIMIT SWITCH
ADJUSTMENT
AND DOWN
WHITE LIMIT
SWITCH
ADJUSTMENT
NOTE:
OPERATING SWITCH AND
MUST BE WIRED TO CONFORM TO LOCAL WIRING
PLATE FURNISHED WITH
CODE. THIS SWITCH CANNOT BE USED WITH L.V.C.
SCREEN.
JUNCTION
BOX
4
IN MULTIPLE CONTROL INSTALLATIONS THIS
SWITCH IS REPLACED BY THE LOW VOLTAGE
CONTROL, OPERATED FROM PUSH BUTTON
STATIONS.
FIGURE 3
Drukuj stronę