Da-Lite DESIGNER DA-TAB ELECTROL Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria do projektorów Da-Lite DESIGNER DA-TAB ELECTROL. Da-Lite DESIGNER DA-TAB ELECTROL 6 stron.

Drukuj stronę

SCREEN ADJUSTMENT FOR 220/240V SCREENS

Screen travel is stopped automatically in the down and up positions by the limit switches that are preset at the

factory. If it's necessary to adjust for more or less drop follow the steps below. The case cover must be removed

to access the motor limit switches.

Remove the case cover screw from both ends of the screen. See figure 4. Be sure to hold the cover while

removing the screws.

Rotate the cover up and away from the case until it can be removed.

SETTING THE DOWN LIMIT POSITION

TO REDUCE SCREEN DROP:

Turn the white limit switch screw clockwise to decrease the amount of screen drop. Run the screen down

to test the stop position. If the screen drops too far, raise the screen about one foot and adjust the limit

switch again. Repeat until the desired position is set.

TO INCREASE SCREEN DROP:

Turn the white limit switch screw counterclockwise to increase the amount of screen drop. Run the screen

down to test the stop position. If the screen does not drop enough, raise the screen about one foot and

adjust the limit switch again. Repeat until the desired position is set. Do not adjust for more drop than what

was ordered. At least 1-1/2 wraps of fabric must remain on the roller.

SETTING THE UP LIMIT POSITION

▲

CAUTION: Do not allow the slat bar to wrap over the top of the roller when the screen is rolling into the case. The

screen could be damaged.

SCREEN TRAVELS INTO CASE TOO FAR:

Turn the red limit switch screw clockwise to decrease the amount of travel. Run the screen up to test the

stop position. If the screen does not stop properly, lower the screen about one foot and turn the limit

switch again. Repeat until the desired position is set.

SCREEN DOES NOT TRAVEL FAR ENOUGH INTO CASE:

Turn the red limit switch screw counterclockwise to increase the amount of up travel. Run the screen up to

test the stop position. If more travel is desired, lower the screen about one foot and adjust the limit switch

again. Repeat until the desired position is set.

DESIGNER DA-TAB ELECTROL

220 / 240V

WIRING DIAGRAM

EXTERNAL WIRING

TO JUNCTION BOX, MOUNTED IN

TO BE COMPLETED

SCREEN CASE, IN WHICH INTERNAL

BY INSTALLER.

WIRING TERMINATES IN BLUE,

BROWN AND BLACK LEADS.

OFF

DOWN

REAR VIEW OF DPDT,

WITH CENTER OFF.

THIS SWITCH CANNOT BE USED WITH LVC.

NOTE: A single switch cannot be used to operate more than

one screen. Contact the factory for further information.

INSTALLATION

OPERATING SWITCH,

SWITCH BOX, AND

BROWN /

PLATE FURNISHED

YELLOW

WITH SCREEN.

ROCKER

BROWN AC HOT

SWITCH

BLUE AC COMMON

220 /240V. AC 50HZ.

2 AMP. MAX.

BLUE JUMPER WIRE

DOWN WHITE LIMIT

SWITCH KNOB

NOTE: MUST BE WIRED TO CONFORM TO

LOCAL WIRING CODE. THIS SWITCH

CANNOT BE USED WITH L.V.C.

IN MULTIPLE CONTROL INSTALLATIONS

THIS SWITCH IS REPLACED BY THE LOW

VOLTAGE CONTROL, OPERATED FROM

PUSH BUTTON STATIONS.

JUNCTION

BOX

MOTOR

UP RED LIMIT SWITCH KNOB

FIGURE 3