American Standard H2Option 2887 Instrukcja instalacji - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Toalety American Standard H2Option 2887. American Standard H2Option 2887 7 stron.
Drukuj stronę
6
BOLT CAP
WASHER
NUT
INSTALL TOILET
a.
Position toilet squarely to wall and, with a rocking motion, press bowl
down fully on wax ring and flange. Alternately tighten nuts until toilet
is firmly seated on floor.
DO NOT OVERTIGHTEN NUTS
OR BASE MAY BE DAMAGED!
b.
Install caps on washers. (If necessary, cut bolt height to size before
installing caps.)
c.
Smooth off the bead of sealant around base. Remove excess sealant.
8
INSTALL TOILET SEAT Install toilet seat in accordance with manufacturer's directions.
9a
Before continuing, determine the type of water supply connection you have from the chart below
and use the appropriate assembly parts required to properly reconnect the water supply.
METAL / COPPER
METAL FLANGED
FLARED TUBING
LOCK NUT
CONE
WASHER
COUPLING
NUT
WATER
SHUT-OFF
These parts must be used as
illustrated to ensure water-tight
connection. Use of existing
coupling nut may result in water
leakage. Water supply tube or
pipe must extend at least 1/2"
inside threaded shank of valve
(does not apply to flanged tubing).
CAUTION: DO NOT USE
CONE WASHER WITH
PLASTIC SUPPLY LINE.
WARNING: Do not use plumber's putty, pipe dope, or any other sealant on the water supply
!
connection to this tank. If the connection leaks after hand tightening, replace the supply line. If
the connection continues to leak with the new supply line, replace the fill valve.
Warranty is void if any type of sealant is used on the water supply connection.
CLOSET FLANGE
CLOSET BOLT
!
CAUTION:
METAL SPIRAL
TUBING
TUBING
LOCK NUT
EXISTING
WASHER
EXISTING
COUPLING
NUT
WATER
SHUT-OFF
Use existing coupling
Use existing spiral cone
nut and washer.
washer. Fluidmaster cone
washer may not seal
completely on spiral type
supply line.
CAUTION: Overtightening of LOCK
NUT or COUPLING NUT could result
in breakage and potential flooding.
7
INSTALL TANK
a.
Insert rubber grommets through holes in the tank then
insert bolts through holes in the grommets.
b.
Install large rubber gasket over threaded outlet on bottom
of tank and lower tank onto bowl so that tapered end of
gasket fits evenly into bowl water inlet opening.
c.
With tank parallel to wall, alternately tighten nuts until tank
is snugged down evenly against bowl surface.
DO NOT OVERTIGHTEN NUTS MORE
VINYL / BRAIDED
CONNECTOR
LOCK NUT
LOCK NUT
EXISTING
COUPLING
CONE
NUT
WASHER
COUPLING
NUT
WATER
WATER
SHUT-OFF
SHUT-OFF
Captive cone washers
already included. No
additional washers needed.
- 2 -
RUBBER
GROMMET
RUBBER
TANK MTG.
GASKET
BOLTS
WASHER/NUT
!
CAUTION:
THAN REQUIRED FOR A SNUG FIT!
9b
With correct washers in place (see
Step 9a), tighten COUPLING NUT
1/4 turn beyond hand tight.
DO NOT OVERTIGHTEN.
7 3014 16 - 10 0 Rev. L 1 /16