American Standard NEO MODERN CCAS2073 Instrukcja instalacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Toalety American Standard NEO MODERN CCAS2073. American Standard NEO MODERN CCAS2073 4 stron.

Drukuj stronę

TROUBLE SHOOTING GUIDE

Problem

1. Poor flushing action

2. Water won't stop

running

3. Water supply hose

leaks

CARE AND MAINTENANCE

Do not use harsh abrasives or caustic cleansers to clean fixture surface. A mild detergent, warm water, and a

softcloth will remove normal dirt and soap accumulations from fittings and surfaces. Rinse thoroughly after

cleaning and polish with a soft dry cloth to restore original luster of material.

Notice

Do not use cleansers in tank. Products containing chlorine (calcium hypochlorite) can seriously damage

fittings in the tank. This damage can cause leakage and property damage. American Standard shall not

be responsible or liable for any tank fitting damage caused by the use of cleaners containing chlorine

(calcium hypochlorite).

Using this guide and referring to the accompanying instructions should help you solve most

common problems encountered.

Possible Cause

a. Water level in tank is below prescribelevel.

b. Flush valve mechanism in tank closes too quickly

or does not open.

c. Flush handle or button needs replacing.

d. Water pressure is too low.

e. Partially clogged trapway and / or drainpipe.

f. Cleanser used in tank deposits residue.

g. No air vent.

a. Water level in tank is higher than overflow pipe.

b. Turn off the water supply. If water continues to

flow into the bowl the flush valve seat and / or

rubber seal disk are worn or deformed.

c. Turn off the water supply valve. If water continues

to flow into the bowl until the water level falls to

the level of the overflow pipe, sand or debris may

be lodgeg in the water control mechanism.

d. Flush valve string is too tight, holding the flush

valve open.

e. Button needs replacing.

a. Improper installation

b. Water pressure is too high.

To Correct

a. Set to prescribed level.

b. Make sure there are no any material stuck

to outlet components.

c. Replace.

d. Normal water supply pressure must be at least

20 psi.

e. Use a plunger or toilet augur to unclog.

f. Clean out tank and cease using the cleanser.

g. Install air vent per instructions.

a. Adjust the cylinder to maintain the water at the

prescribed level.

b. Replace seat, rubber seal disk, or complete

assembly, as needed.

c. Shut off water supply valve. Remove top cap

of water control. Clean and reassemble, or

replace plunger.

d. Replace fulsh valve unit.

e. Replace button.

a. Reinstall, according to instructions.

b. Water pressure must not exceed 80 psi.

- 4 -

Jan .19

Rev.05