EKF Diagnostics Lactate Scout+ Instrukcja instalacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przyrządy pomiarowe EKF Diagnostics Lactate Scout+. EKF Diagnostics Lactate Scout+ 18 stron. Instructions for bluetooth installation for hand-held lactate analyzer

Drukuj stronę

Wait until the driver installation is finished:

Attention: If you are using the Lactate Scout Data Link Software, no additional

steps are needed for the Bluetooth installation. You can proceed directly with

the installation of the software (see "Software installation and user manual",

p. 4). Otherwise continue with the installation as follows:

2. Next, switch on the Lactate Scout+ in "Setting and Storage Mode":

Before it is switched on, make sure that there is no sensor plugged

into the device. Turn on the device by pressing the scroll wheel for two

seconds and turn the scroll wheel until a blinking "set" and a blinking

Bluetooth

icon „

" appear on the LCD screen:

After pressing the scroll wheel

briefly, the menu is activated and

the message "OFF" is displayed on

the main display together with the

blinking Bluetooth

icon:

After pressing the scroll wheel briefly, the Bluetooth

activated. Please note: The device will turn off automatically after

five minutes if no user input is detected. However, you can turn on

the device again as already described above and continue working.

(See Lactate Scout+ manual).

By turning the scroll wheel by

one click, the message "On" is

appearing on the LCD screen

together

with

outlined

Bluetooth

icon „

module is