EKHO EK-WL8-SND/AU Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wyposażenie morskie EKHO EK-WL8-SND/AU. EKHO EK-WL8-SND/AU 8 stron. Wireless wall sounder

STFV.425412.001-AU-UM rev. 20

INDICATION

The device has a LED which indicates its state according to the following:

No indication or green flashes

Yellow flashes every 4 seconds

Frequent red flickering

TESTING

To test the device, activate an alarm condition on the system via a call-point or fire

sensor. The sounder should activate with the selected tone and volume.

To stop the test silence and reset the control panel.

АNALOG DATA

The device provides the translator module with analog data about air temperature

and voltage levels on its batteries. This information can be viewed in the "Ekho

Configiurator" software.

By analyzing the voltage levels, you can manage maintenance procedures and

predict when you will have to replace the batteries.

WARNINGS & LIMITATIONS

Devices use high quality electronic components and plastic materials that are highly

resistant to environmental deterioration. However, after 10 years continuous

operation it is advisable to replace them to reduce the risk of reduced performance

caused by external factors. Ensure the devices are only used with compatible

control panels. Detection systems must be checked, serviced and maintained on a

regular basis to confirm correct operation.

Refer to and follow National Codes of Practice and other internationally recognized

fire engineering standards. Appropriate Risk Assessment should be carried out

initially to determine correct design criteria and updated periodically.

LED indication

EK-WL8-SND/AU

WIRELESS SOUNDER

20.07.2021

Device's state

Standby mode

Fault state – low battery

Device is activated

Page 5 from 8