American Standard ASYSTAT606 Instrukcja obsługi i informacje - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja obsługi i informacje dla Termostat American Standard ASYSTAT606. American Standard ASYSTAT606 6 stron. Heating/cooling two stage heating single stage cooling manual thermostat
Drukuj stronę
Setting the Fan Switch
The Fan Switch may be set at:
AUTO or ON.
When the Fan Switch is set to
AUTO, the indoor fan will cycle
"on" with the call for heating or
cooling and "off" when the
thermostat is satisfied. This "on"
and "off" cycle is controlled by
the thermostat as it operates the
system to maintain the selected
indoor temperature. This mode of
operation will provide the lowest
operating cost and better humidity
control in cooling operation.
When the "FAN" switch is in the
"ON" position the fan will run
continuously. With the "FAN" in
the "ON" position your cooling
and heating system will still
operate as the conditioned space
temperature requires, but the
indoor fan will not cycle off. It will
continue to run when there is no
heating or cooling required. This
provides constant air filtering and
more even air distribution to all
conditioned spaces. In some
cases, particularly with multi-level
homes, comfort may be enhanced
by continuous circulation of indoor
air.
To turn the system OFF, position
the switches as follows:
SYSTEM — OFF; FAN — AUTO:
CAUTION: In cooling mode, rapid
changing of the thermostat
temperature setting in such a
manner that turns the compressor
OFF and ON rapidly may cause
the compressor motor protector
to open and turn OFF the
compressor for a short time.
The protector is an automatic reset
type and the compressor
will restart after a few minutes.
"Jiggling" the thermostat is not
recommended. Anytime the
system is turned OFF, allow
approximately 5 to 10 minutes for
system pressures to equalize
before restarting.