American Time SiteSync IQ Instrukcja instalacji i obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Sprzęt nagrywający American Time SiteSync IQ. American Time SiteSync IQ 13 stron. Wireless system controller with standard gps & magnetic mount tx antenna
Również dla American Time SiteSync IQ: Skrócona instrukcja instalacji (2 strony), Instrukcja instalacji i obsługi (2 strony), Instrukcja instalacji i obsługi (7 strony), Instrukcja instalacji i obsługi (6 strony), Skrócona instrukcja instalacji (2 strony), Skrócona instrukcja instalacji (2 strony), Skrócona instrukcja instalacji (2 strony), Skrócona instrukcja instalacji (2 strony), Skrócona instrukcja instalacji (2 strony), Skrócona instrukcja instalacji (2 strony), Skrócona instrukcja obsługi (2 strony), Skrócona instrukcja obsługi (2 strony), Skrócona instrukcja obsługi (2 strony)

SiteSync IQ Wireless Controller

Installation Manual

SiteSync IQ Wireless Controller power LED OFF when power is connected

• Verify power switch is in the ON position

• Disconnect power to the SiteSync IQ Wireless Controller and remove the junction box cover. Restore power and carefully check

for 120vac between terminals H and N.

• Disconnect power and remove the front panel. Check power input fuse (F2) and replace if necessary.

Secondary Clocks not synchronized with System Controller

• If system controller time was recently changed, allow up to 24 hours for secondary clocks to re-synchronize to the

system controller.

• Make sure there is sufficient voltage across each secondary clock.

• If fewer than 25 secondary AllSync clocks are connected to the SiteSync IQ Wireless Controller, the secondary clocks might

not recognize the correction from the SiteSync IQ Wireless Controller. Connect all intended clocks and allow time for the

normal SiteSync IQ Wireless Controller correction. If secondary clocks still have not corrected, you may need to disable surge

suppression circuitry (set surge switches S7 and S8 to the OFF position to disable surge suppression circuitry).

• Check for signal reception at installation location. Contact American Time Technical Support or reference the SiteSync IQ Site

Survey instructions.

Signal Circuits Not responding to programmed events

• Make certain that SiteSync IQ System Controller circuits are set to AUTO and signal circuits are enabled. Press

System Controller keypad, enter User Lock, if applicable, then press

• Confirm that signal circuits and events programmed to control them are assigned to the same schedule.

• Check for correct voltage at signal relay contacts.

• Check for signal reception at installation location.

• Check for signal reception at installation location. Contact American Time Technical Support or reference the SiteSync IQ Site

Survey instructions.

Power outage during Daylight Saving Time Correction

• If there is a power outage during the correction period for Daylight Saving Time, the secondary clocks might not correct. In this

event wait for the next 12 hour correction.

Troubleshooting

on the