Dongcheng DMY02-235 Instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Piła Dongcheng DMY02-235. Dongcheng DMY02-235 10 stron. Electric circular saw
Drukuj stronę
application. The correct power tool will do the job better and safer at the rate
for which it was designed.
18. Do not use tool if switch does not turn it on or off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
19. Disconnect the plug from the power source and/or the battery pack
from the power tool before making any adjustments, changing
accessories, or storing power tools. Such preventive safety measures
reduce the risk of starting the power tool accidentally.
20. Store idle power tools out of the reach of children and do not allow
persons unfamiliar with the power tool or these instructions to operate
the power tool. Power tools are dangerous in the hands of untrained users.
21. Maintain power tools. Check for misalignment or binding of moving
parts, breakage of parts and any other condition that may affect the
power tool's operation. If damaged, have the power tool repaired before
use. Many accidents are caused by poorly maintained power tools.
22. Keep cutting tools sharp and clean. Properly maintained cutting tools with
sharp cutting edges are less likely to bind and are easier to control.
23. Use the power tool, accessories and tool bits etc. in accordance with
these instructions, taking into account the working conditions and the
work to be performed. Use of the power tool for operations different from
those intended could result in a hazardous situation.
Service
24. Have your power tool serviced by a qualified repair person using only
identical replacement parts. This will ensure that the safety of the power
tool is maintained.
VOLTAGE WARNING:
Before connecting the machine to a power source (receptacle, outlet, etc.), be
sure the voltage supplied is the same as that specified on the nameplate of the
machine. A power source with voltage greater than that specified for the machine
can result in SERIOUS INJURY to the user, as well as damage to the machine. If
in doubt, DO NOT PLUG IN THE MACHINE. Using a power source with voltage
less than nameplate rating is harmful to the motor.
-3-
SPECIFICATIONS
Rated Power Input
No-Load Speed
90°
Max. Cutting Depth
45°
Max. Cutting Angle
Max. Dia. Of Blade
Net Weight
※ Due to the continuing program of research and development, the specifications
herein are subject to change without prior notice.
ADDITIONAL SAFETY RULES
DANGER:
1. Keep hands away from cutting area and blade. Keep your second hand on auxiliary
handle, or motor housing. If both hands are holding the saw, they cannot be cut by
the blade.
2. Keep your body positioned to either side of the saw blade, but not in line with the
saw blade. KICKBACK could cause the saw to jump backwards.
3. Do not reach underneath the work. The guard can not protect you from the blade
below the work. Do not attempt to remove cut material when blade is moving.
CAUTION: Blades coast after turn off. Wait until blade stops before grasping cut
material.
4. Adjust the cutting depth to the thickness of the workpiece. Less than a full tooth of
the blade teeth should be visible below the workpiece.
5. NEVER hold piece being cut in your hands or across your leg. It is important to
support the work properly to minimize body exposure, blade binding, or loss of
2000W
4100 r/min
85mm
60mm
50°
235 mm
6.5 kg
-4-