Air Creation RACER 503 Instrukcja obsługi i konserwacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Rower Air Creation RACER 503. Air Creation RACER 503 18 stron.

III) Instructions for use

Warning: Due to the low load on the front wheel of the trike, carrying and maneuvering on

the ground without wing must be done carefully in order to prevent any falling on the

propeller.

a) Retrofits

The RACER trike can be equipped with any mono seater wing of our manufacture. If the wing to

be fitted was not supplied with the trike when purchased (different make or second-hand), make

sure that the clearance between the propeller and the rear and keel longitudinal cables is at least 10

cm with the propeller at full pitch.

b) Assembling - Dismantling

• Lift the wing, positioning it on the nose and into the wind.

• Wheel the trike behind the wing and line it up with the keel.

• Raise the upper monopole, run the cable hook onto the wing rail, position the # 10 bolt and

install the butterfly nut and the locknut.

• Slip the back-up fastening cable into the belt loop at the king post, running it once around it.

Slip it through the belt loop again and fasten it to the trike monopole. The back-up fastening

cable should be run under the tensioning cables. This operation secures the trike to the wing,

also securing the wing cross-bar tensioning system.

• Place the propeller in a horizontal position.

• Raise the wing nose in a horizontal position.

• Attach the front strut between the aluminum flanges at the top of the upper monopole using the

bolt and the butterfly nut.

• Pick up the 'A' frame tubes, take hold of the control bar and lift the wing while keeping the trike

from falling over or wing backwards. The front strut can be fitted into the keel opening when

the wing is lifted high enough. When alone, sit down on the trike keel facing the 'A' frame, take

hold of the control bar, place it on your knees, raise the wing and fit the front strut as indicated.

• First install the upper monopole safety bolt at the engine support using the butterfly and lock

nuts, then install the front strut fastening bolt to the lower trike monopole at the fork.

• Install the foam seat upholstery using the Velcro tabs.

Dismantling is carried out in reverse order of the assembling operations.

Instruction and Maintenance HandBook RACER

AIR CREATION Aérodrome de Lanas - 07200 AUBENAS - France

Tél. : 33 (0) 4 75 93 66 66 - Fax : 33 (0) 4 75 35 04 03 - Internet : www.aircreation.fr

EDITION : JUNE 2005

PAGE : 4