Astin Trew AT5000 Instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Astin Trew AT5000. Astin Trew AT5000 10 stron. Dual mono power amplifier
Drukuj stronęwell ventilated area and kept away
from sources of heat, dust, humidity
and direct sunlight.
Do not attempt to change or alter any
component or part of this amplifier
except for those which are user
replaceable (see sections 6 and 7).
Unauthorised adaptations will
void the warranty and may
damage the amplifier.
Clean the outside surfaces with a dry
lint free cloth. Some cleaning and pol-
ishing agents may cause marking to
the surface finishes.
All electronics is susceptible to local
lightening strikes affecting the mains
cabling in your home. When not in
use, the safest option is to remove
the mains plug from the wall socket.
5. Set up
The mains lead supplied with has an
IEC mains plug on one end which plugs
into the amplifiers rear panel. The
other end is fitted with an appropriate
mains plug of your country. In the UK
this is the standard UK13A plug.
The high-quality performance of this
amplifier will be impaired if the electri-
cal supply to it is in poor condition.
We recommend that you use a high
quality wall socket directly, or a multi-
way socket unit designed for audio
use. If you live in an area with very
'dirty' or variable mains supply, you
may also wish to try a power supply
conditioner to optimize fidelity.
The RCA phono input connections
should be connected to an appropriate
pre-amplifier or other audio equipment
with an output volume control. We
recommend the use of high-quality sig-
nal cables for optimum performance.
Placing the equipment on an audio
equipment rack, table or support,
offering maximum isolation from
mechanical vibration is recommended.
The loudspeaker connectors will
accept either bare wire, 4mm banana
plugs or spade terminals. Use high
quality loudspeaker cables for optimum
performance. There are two pairs of
outputs for both channels, allowing
you the option of bi-wiring your loud-
speakers if they are designed for this
option and you wish to experiment.
See Illustration, page 5.
Ensure that the loudspeaker cables
are fitted in phase. Do not short out
the cables when in use as this may
damage the amplifier.
3