Donner Force 2 Instrukcja obsługi - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Donner Force 2. Donner Force 2 2 stron.
Drukuj stronę
Connections & Controls
a
d
e
f
d
f
g
g g
g
g
h
c
i
a
DC 9V Jack:
For power supply, use a 9-volt DC
regulated by AC adapter, 500mA
(plug polarity is positive on the barrel
and negative in the center).
b
Input Jack:
1/4" mono audio jack, for connecting
instrument.
Output Jack:
c
1/4" mono audio jack, for connecting
to an amplifier.
LEVEL Knob:
d
Adjusts the effect output.
REVERB Knob:
e
Adjusts the reverb level.
f
GAIN Knob:
b
Adjusts the effect gain amount.
g
LOW/MIDDLE/HIGH Knob:
3-band EQ for tone shaping.
CAB SIM Button (with LED):
h
Press to switch the cab simulator
on/off (the LED will continue flashing
while the cab simulator is on). Press
and hold to switch between the two
channels:
Channel A: based on Soldano SLO
100* Normal channel (Clean, green
LED);
Channel B: based on Soldano SLO
100* Overdrive channel (Crunch, red
LED).
Footswtich Modes
i
The footswitch can be configured as
an on/off switch (mode 1) or an A/B
channel switch (mode 2). The default
is mode 1. To switch to mode 2, press
and hold the footswitch for 2 seconds
when the pedal is on.
The LED will flash to indicate mode
selection. In mode 2, the pedal cannot
be bypassed; tapping the footswitch
means toggling between channels. To
switch back to mode 1, press and hold
the footswitch for 2 seconds again.
Features
●Convenient compact size
●Digital circuit design
●Two-channel preamp with organic
tube amp sound
●Sounds based on Soldano SLO 100*
●Built-in reverb and cabinet simulator
Specifications
Power Requirement: 9V DC center
negative
Current Consumption: 200mA
Dimensions: 42x93.5x52mm
Weight: 230g
www.donnerdeal.com
I
*The mentioned manufacturers and product
names are trademarks or registered trademarks
of their respective owners which were used
merely to identify the sound character of this
product.