AMERICANA OUTDOORS COLONIAL Instrukcja montażu

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Schronienia AMERICANA OUTDOORS COLONIAL. AMERICANA OUTDOORS COLONIAL 5 stron.

Before You Begin:

Recommended Tools:

Note on Electric Drills:

Note on Roof Panel Spacing:

Note on Caulk and Sealing:

Note on Cutting and Drilling:

If you have any questions during installation, please call us at 1-888-442-2928

1) Please read all instructions and notes carefully. Check the Parts List or Bill of Materials for

any missing parts and gather necessary tools. To prevent scratching of painted materials,

place on a tarp, paper, or other protective material.

2) You may be required to obtain a building permit for this structure from your local building

authority. Contact your local building department for details.

3) Note that this shade structure is not designed to carry additional loads such as hanging

heavy plants, swings, people, or other objects.

Saftey Glasses, Tape Measure, Carpenters Level, Framing Square, Hex Head Nut Drivers,

Chalk Line, Electric Drill w/ Bits, Pliers, Metal Hack Saw, Silicone Caulking,

Regular and Phillips Screw Drivers

We recommend lowering the speed of your drill during this installation. Installing Tek screws

at a high rpm may cause the Tek screws to become damaged or break during installation.

The center to center of roof panel lock spacing MUST be maintained as the panels are

installed. If this is not done, problems may not show up until towards the end of installation

when parts may appear to be cut too short or too long. If this happens, go back and check the

spacing and re-set if necessary. The spacing is 24" for the W shaped panel, 10" for the

V shaped panel, and 8" or 18" for the flat panel.

We strongly recommend using a high grade sealant, such as our 100% Silicone Caulk and Sealant.

Caulking should be applied uniformly without skips. A poor caulking job can cause leaks.

Cutting and drilling will cause metal shavings. These shavings must be carefully removed by

sweeping or brushing. If this is not done, the metal shavings will quickly rust and stain the

surface finish.

COLONIAL SHELTER

ASSEMBLY INSTRUCTIONS

Rev. - 3/01/2012