Donovan Sidewinder Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Części zamienne do ciężarówek Donovan Sidewinder. Donovan Sidewinder 16 stron. Electric side-flip tarp system

Drukuj stronę

P/N 1809453 Rev. A

HINGE INSTALLATION

STEP 1: Lid hinges may be mounted either by welding or by

bolts. If welding, move to Step 2. If bolting,skip to Step 3.

STEP 2: Locate front, center and rear hinge positions. Weld

hinges in place to steel trailer. Use caution to protect chrome

cylinder rod from weld splatter. Skip Steps 3-5 if hinges are

welded.

APPROX. CENTER

LINE OF TRAILER

8" (20.3 CM)

NOTE: For trailers with center support above top rail, offset

center hinge to either side of support.

STEP 3: Locate front, center and rear hinge positions. Mark

hinge hole positions.

APPROX. CENTER

LINE OF TRAILER

8" (20.3 CM)

STEP 4: Remove hinges and drill 17/32" (13.5mm) holes in

marked locations on side of top rail. Drill and tap marked loca-

tions on top of top rail for 1/2" bolts .

STEP 5: Reposition hinges and mount using 1/2" Grade 5 bolts

or better (bolts not supplied).

DONOVAN

8.75" (22.2 CM)

HELP LINE: 1-800-327-8287

Hinge Installation/Lid Extension Assembly

LID EXTENSION ASSEMBLY

STEP 1: Starting with front lid, noted by having a C-channel and

additional gussets, measure outside-to-outside width at front of

trailer at top rail. Slide extension tube into front lid matching this

measurement then weld in place.

NOTE: Orientation of angle will be pointing toward ground

when lid is mounted to trailer.

ANGLE POINTS DOWN

WELD FOUR SIDES

WIDTH AT FRONT

STEP 2: Repeat process measuring outside-to-outside width at

center and rear of trailer. Adjust extension tubes for center and

rear lids respectively.

NOTE: Center lid extension will not have a cable attached,

but will get two turn-buckles at a later step. The rear lid has

no C-channel or additional gussets as compared to front lid.

OF TRAILER