Astor-Bannerman ABW-CP Instrukcja instalacji i obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Spryskiwacz Astor-Bannerman ABW-CP. Astor-Bannerman ABW-CP 13 stron.

Pre-installation information

Fig 4

Plumbing:

Fit cold

(on left)

and hot

(on

right) outlets with their centres at 200mm above the floor, pointing

upwards, offset to the left of the centreline of the unit by 140mm terminating with 3/4" BSP

washing machine isolation valves. These feeds will be enclosed by 50x75mm trunking upon

installation. Fit a 32mm/1¼" waste pipe with its centre at 200mm above the ﬂoor, on the centreline

of the unit.

Electrics:

The ABW-CP is supplied by mains electric (30v) and transformed to 4v within the unit. A 30mA

RCD protected fused spur is required, with a flush mounted ﬂex outlet cover, on the wall behind the

unit at a height of 1100mm from the ﬂoor on the centreline of the unit.

Fixing:

The basin assembly should be ﬁxed to a load bearing wall (i.e. strong enough to carry a 100kg load

on wall ﬁxing) which is ﬂat and free from obstruction from 200mm – 2200mm above the ﬂoor. If

the basin needs to be ﬁxed to a stud wall, the wall will need special reinforcement, either

150mm/6" noggins as shown above or 25mm/1" marine or exterior plywood may be used to cover

the entire ﬁxing area, secured to the stud work every 200mm.

Page: 5

Version 4 : 25-09-019