Door Controls DC One Instrukcja instalacji - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla System otwierania drzwi Door Controls DC One. Door Controls DC One 20 stron. Automatic sliding door retrofit drive assembly

Drukuj stronę
9.

SAFETY TEST AND DOCUMENTATION

When all DC One and sensor adjustments are complete, perform a thorough safety test to validate proper and safe performance
in accordance with current ANSI A156.10 guidelines as well as recommendations prescribed by the American Association of
Automatic Door Manufacturers (AAADM). Door Controls USA recommends this step be performed by an AAADM certified door
inspector.
Walk toward the door at a normal pace. The door should open when you are about 4 feet from the door.
•
Stand motionless on threshold for at least 10 seconds. The door should not close.
•
Move clear of the area. The door should remain open for at least 1.5 seconds and should close slowly and
•
smoothly.
Repeat steps 1 through 3 from the other direction if door is used for two way traffic.
•
Inspect the floor area. It should be clean with no loose parts that might cause the user to trip or fall. Keep traffic
•
path clear.
Inspect door's overall condition. The appropriate signage should be present.
•
Have door inspected by an AAADM certified inspector at least annually.
•
DO NOT USE DOOR if it fails any of these safety checks or if it malfunctions in any way.
•
Be sure to place an AAADM Daily Safety Check decal on the door (usually near the On-Off switch).
Document all work, obtain signatures on all work orders, and instruct the owner on door operation. Be sure to leave a copy of
the AAADM Owner's Manual for sliding doors with the owner or facilities manager.

10. CONTROL LAYOUT

A
A. Transformer
B. Transformer Connector
C. Power Connector
D. Status LEDs
E. Display Screen
F. Parameter Adjustment Knob
G. Encoder Status LEDs
H. Encoder Connector
I.
Sensor Connector
J.
Multifunction Switch Connector
DC One V3 Installation Manual
M-0015 REV 06222017 P10
D
B
C
R
T
S
F
E
Q
P
O
N
K. Special Modes Connector
L. Lock Connector
M. Test Button (activates door)
N. Program Button
O. Down Button
P. Up Button
Q. Reset Button
R. Lock Voltage
S. Display Intensity
T. Motor Connector
I
G H
J
L
K
M
Page 4 of 15