Door Entry Direct 603S Instrukcja instalacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla System interkomu Door Entry Direct 603S. Door Entry Direct 603S 2 stron. Wireless intercom system

Drukuj stronę
Keypad Programming (only SK models)
The amber LED indicates standby mode (flashing), or programming
mode (ON).
Green LED indicates output 1 active.
Red LED indicates output 2 active.
Enter Programming mode
0
0
0
0
*
Choosing single user mode or multi user
For most installations, it is sufficient to add a single keypad code for all
users. However, you can program up to 99 codes for relay 1 and 10
codes for relay 2. To do this, you need to first put the unit into multi
mode.
8
9
0
0
#
8
9
0
1
#
Programming User codes for SINGLE USER mode
0
?
?
?
?
#
1
?
?
?
?
#
2
?
?
?
?
#
Programming User codes for MULTI USER mode
0
?
?
?
?
#
1
?
?
?
?
?
User number 00-99
Code 4-8 digits
2
?
?
?
?
?
User number 0-9
Code 4-8 digits
Programming Relay output modes
4
0
?
?
?
#
#
4
1
5
0
?
?
?
#
#
5
1
Restore Defaults
1) Disconnect the power supply.
2) Put the DAP jumper in the ON position.
3) Re-connect the power supply. The buzzer will be activated.
4) Put the DAP jumper back in the OFF position.
5) The keypad is now in programming mode, ready to receive data.
Additional keypad information
EG IN (EGRESS INPUT)
A Normally Open (N.O.) input terminal refers to (-) ground, with the help of a normally open button
to activate the Output 1 for the same time period as the user code. Egress button is usually put
inside the house near the door. More than one egress buttons can be connected in parallel to the
terminal. Leave this terminal open if it is not used.
KEY ACT.(KEYPAD ACTIVE OUTPUT)
An NPN transistor open collector output. It switches to (-) ground for 10 seconds on each key
touching. This can be used to turn on lights, CCTV camera, or buzzer to notify a guard. The rating
of this output is: Ic max: 100mA sink, Vc max: 24VDC
DU OUT (DURESS OUTPUT)
An NPN transistor open collector output. It switches to (-) ground after the Duress Code is entered.
Use it to trigger an alarm zone, or turn on a buzzer to notify a guard. Ic max: 100mA sink. Vc max:
24VDC
The unit is now in programming mode. Amber LED
will remain ON. 0000 is default programmers code.
Note: Pressing * again will exit programming mode.
Set to SINGLE USER mode and refresh system.
Set to MULTI USER mode and refresh system.
Enter NEW MASTER programming code.
Enter user code for relay 1.
Enter user code for relay 2.
Enter NEW MASTER programming code.
(4-8 digits for all multi codes!)
Enter up to 100 user codes for relay
?
#
output 1
Enter up to 10 user codes for relay
#
output 2
Output 1 in momentary mode. ??? Can be 1-3
digits, 1-999 seconds
Output 1 in latching or toggle mode.
Output 2 in momentary mode. ??? Can be 1-3
digits, 1-999 seconds
Output 2 in latching or toggle mode.