Door-Gard 232se Funkcje i instrukcja programowania - Strona 3
Przeglądaj online lub pobierz pdf Funkcje i instrukcja programowania dla Keypad Door-Gard 232se. Door-Gard 232se 4 stron. Self-contained access control systems keypad
Drukuj stronę3
.
1. Enter programming mode
2. Change master code/set main relay time
Example: Master code of 4321/relay time of 10 seconds
3. Add/change user code
4. Add/change user code to toggle main relay
5. Delete user codes
6. Turn keypress feedback/audible keypress on
7. Turn keypress feedback/audible keypress off
8. Turn yellow LED/sounder on with relay
9. Turn yellow LED/sounder off with relay
10. Turn auto entry on
11. Turn auto entry off
12. Turn keypad active on
13. Turn keypad active off
14. Set propped door time
15. Set forced door relay time
16. Erase keypad memory/reset defaults
NOTES:
1 Time must always be represented by 2 digits. Example: 5 seconds = 05.
Latching /toggle is accomplished by entering a time of 00
2 Keypad active is a negative voltage output (sink) available
on terminal (or wire) marked WB (see wiring diagrams for location).
3 Propped Door and Forced Door times must be programmed in intervals of
10 seconds. ie. 10, 30, 60, ... up to 900 seconds.Forced door time of 00 will latch output, until reset by code.
1
1
2
3
3
Press
99 # (master code) *
Press
( time) # 1 # (new code) * (new code) *
Press
10 # 1 # 4321 * 4321 *
Press
(user number) # (new code) * (new code) *
Press
(00) # (user number) # (new code) * (new code) *
Press
(user number) # * *
Press
30 # 0 # 1 # * *
Press
30 # 0 # 0 # * *
Press
30 # 1 # 1 # * *
Press
30 # 1 # 0 # * *
Press
30 # 2 # 1 # * *
Press
30 # 2 # 0 # * *
Press
43 # 0 # 99 # * *
Press
43 # 0 # 00 # * *
Press
44 # (time) # 0 # * *
Press
45 # (time) # 0 # * *
Press
46 # 00000 # 00000 # * *