DAB PUMPS ACTIVE DRIVER T/T 3.0 Instrukcja instalacji i konserwacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji i konserwacji dla Systemy kontroli DAB PUMPS ACTIVE DRIVER T/T 3.0. DAB PUMPS ACTIVE DRIVER T/T 3.0 16 stron.

Drukuj stronę

INDEX

GENERAL

WARNINGS

APPLICATIONS

TECHNICAL DATA AND LIMITATIONS OF USE

ELECTRICAL CONNECTIONS OF THE ACTIVE DRIVER TO THE ELECTROPUMP

CONNECTION TO THE POWER SUPPLY LINE

HYDRAULIC CONNECTIONS

CHARACTERISTICS – INTERPRETATIONS – OPERATION

8.1

Characteristics and interpretations

8.2

Operation: keyboard setting

8.3

Operation: parameters for the user

8.4

Operation: parameters for the installer

8.5

Operation: technical assistance displays and settings

DISPLAYS

9.1

Displays of the main values

9.2

Monitor displays

10.

ACCESS TO MANUAL MODE OF THE MACHINE

11.

GENERAL SYSTEM RESET

12.

RESTORING THE FACTORY SETTINGS

13.

ERROR AND STATUS CONDITIONS

14.

TABLE OF INDICATIONS ON THE DISPLAY

GENERAL

Read this documentation carefully before installation. Installation and functioning must comply

with the safety regulations in force in the country in which the product is installed. The entire

operation must be carried out in a workmanlike manner.

Failure to comply with the safety regulations not only causes risk to personal safety and damage to

the equipment, but invalidates every right to assistance under guarantee.

WARNINGS

2.1

Skilled personnel

It is advisable that installation be carried out by competent, skilled personnel in

possession of the technical qualifications required by the specific legislation in force.

The term skilled personnel means persons whose training, experience and instruction, as well as

their knowledge of the respective standards and requirements for accident prevention and working

conditions, have been approved by the person in charge of plant safety, authorizing them to perform

all the necessary activities, during which they are able to recognize and avoid all dangers.

(Definition for technical personnel IEC 364).

2.2

Safety

Use is allowed only if the electric system is in possession of safety precautions in accordance with the

regulations in force in the country where the product is installed (for Italy, IEC 64/2).

2.3

Responsibility

The Manufacturer does not vouch for correct operation of the ACTIVE DRIVER or for any damage

that it may cause if it has been tampered with, modified and/or run outside the recommended work

range or in contrast with other indications given in this manual. The Manufacturer declines all

responsibility for possible errors in this instructions manual, if due to misprints or errors in copying.

The Manufacturer reserves the right to make any modifications to products that it may consider

necessary or useful, without affecting the essential characteristics.

2.4

PARTICULAR WARNINGS

Before working on the electrical or mechanical part of the system, always turn off the mains voltage.

Wait at least five minutes after the power supply to the machine has been switched off before opening

the appliance. The condenser of the continuous intermediate circuit remains charged with dangerously high

voltage even after the mains voltage has been switched off.

Only firmly wired mains connections are admissible. The appliance must be earthed (IEC 536 class 1, NEC

and other relevant standards).

Mains terminals may carry dangerous voltage even when the motor is stopped.

In determined calibration conditions, after a power cut the converter may start automatically.

Pay attention: the motor terminals U, V and W (for the Active Driver M/M 1.1 the motor terminals R

and S). may carry dangerous voltages even when the converter is not operating.

Do not operate the appliance in direct sunlight.

This appliance may not be used as an "EMERGENCY STOP mechanism" (see EN 60204, 9.2.5.4).

ENGLISH

page