DoorHan PCB-SH Instrukcja programowania - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja programowania dla Otwieracz do bram DoorHan PCB-SH. DoorHan PCB-SH 16 stron. Control board
Również dla DoorHan PCB-SH: Instrukcja programowania (14 strony), Instrukcja programowania (12 strony)
Drukuj stronę
1. CONTROL UNIT DIAGRAM
1.1. CONTROL UNIT SCHEMATIC DIAGRAM
CAUTION! Wires in the cable shall be protected against contact with any rough and sharp parts. All connections shall be
performed only when the power is off.
CAUTION! If no devices are connected to PH CL and COM terminal, it is necessary to install a jumper between contacts
PH CL and COM.
Control unit LEDs
LEDs in bold type indicate the state when the door is stopped in the middle position.
LED
Program
SW OP
SW CL
OP
CL
PH CL
STOP
Remote
8
Function
the operation mode is selected
limit switch to open
limit switch to close
OPEN command
CLOSE command
photocells to close
STOP command
record of remote controller code
CONTROL UNIT DIAGRAM
On
flashes according to the selected mode of operation
does not respond
does not respond
on
on
do not respond
off
on
Off
responds
responds
off
off
respond
on
off