DoorHan Sectional-750 Instrukcja instalacji i obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Otwieracz do bram DoorHan Sectional-750. DoorHan Sectional-750 16 stron.
Drukuj stronę
1
DescrIPTIon
DESCRIPTION
8
2
3
10
6
7
ASSEMBLY
Pre-check
design of the gate shall meet the requirements of automation. In particular, check correspondence of the aperture dimensions with the
dimensions, specified in the manual, as well as aperture material rigidity.
•
Check for compliance of the gate with the standards en12604 and en12605 (refer to documentation for the gate).
•
When the gate is moving, there shall be no vehicles, people and others within its coverage area.
•
Check for good order state and intactness of the main moving units of the gate.
•
make sure, that the gate moves without jamming. If required, use special lubricant for cleaning and greasing of the parts of the guide,
do not use fat.
•
Check, if the gate is balanced and if the mechanical stops are installed.
•
Check, that the mechanical door lock I open before using automatic control.
•
make sure, that the minimal clearance between the ceiling and the top point, when the gate is moving, is not less than 35 mm
(pic.4).
•
Check, that the top roller of the gate leaf is in the vertical part of the guide rail, when the gate is completely closed (pic.5).
6
I n s t a l l a t I o n a n d o p e r a t I n g m a n u a l s e C t I o n a l - 7 5 0 / 1 2 0 0
pic. 4
9
2
4
1
5
1
pic. 5
1.
Case cover
2.
panel cover
3.
Key panel
4.
Control board
5.
motor-reducer
6.
transformer
7.
light lamp
8.
microswitch
9.
adapter
10.
protection cover