AMERITRON SDC-103 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kontroler AMERITRON SDC-103. AMERITRON SDC-103 13 stron. Automatic screwdriver antenna controller for icom radios

Drukuj stronę
AMERITRON SDC-103 Instrukcja obsługi
SDC-103 Automatic Screwdriver Controller (ICOM)
received check the connection with your radio. Note: The radio
must be powered on before the SDC-103.
NOTE:
If no data is sent to the controller from the radio the
automatic features of the controller will not function.
3.
The Lowest band / Highest operating frequency will be displayed
if the settings are correct.
4.
Tune the VFO of the radio to the frequency you determined to be
the highest operating frequency of the displayed meter band.
Adjust the antenna using the up/dn buttons until the antenna is
tuned at that frequency.
5.
Once the radio and antenna are tuned at the desired frequency
press the Enter button to save the position.
6.
The controller should display the "band+L" for the lowest
frequency on that band. Set the radio to the lowest frequency of
the band you wish to operate and tune the antenna for resonance,
minimum SWR. Press Enter to store the position and continue to
the next band.
7.
This same procedure should be followed for each of the active
bands selected. When the last low frequency is programmed the
controller will display "Con." Test your settings by changing the
frequency of the radio. Use low power to verify an acceptable
SWR is present before using full power.
Saving Memory Positions
Three antenna positions may be saved by the controller. To store an
antenna position:
a.
b.
Radio Settings
The ICOM radio CI-V settings must be configured to the following:
CIV Baud
CIV ADD 5E
CIV TRN
CIV 731 OFF
Operation
1.
Power on your ICOM radio.
2.
Power on your SDC-103. The controller should display "Con."
3.
Tune the frequency dial on your ICOM radio. The antenna should
begin moving according to your settings.
4.
When the antenna has reached the tuned position apply a low amount
of power 5-10 watts, and verify that the antenna is tuned using an SWR
meter either internal or external to your radio. Small adjustments may
need to be made by pressing the up/dn buttons on the controller Fine
© 2006 Ameritron
Use the UP/DN buttons to tune the antenna.
Press and hold Select, Skip, or Enter until the display reads
done.
AT(AUTO)
ON
Instruction Manual
7