DoorHan PCB-SW Instrukcja programowania - Strona 17

Przeglądaj online lub pobierz pdf Instrukcja programowania dla System otwierania drzwi DoorHan PCB-SW. DoorHan PCB-SW 20 stron. Control board
Również dla DoorHan PCB-SW: Instrukcja programowania (20 strony)

Drukuj stronę

2.2.2. Automatic learning

1. Close the gate and lock the drives (if the ledge is available, adjust the leaves deceleration).

2. Enter the basic programming menu (see Basic Programming section) and select «P3» item.

3. Press the «P» button. Leaf 1 will start to open and the display will show blinking «Ln».

4. If you want to adjust the deceleration, press the «+» button while the gate leaf is moving.

5. After full closing / opening cycle two short beeps will sound and the program will automatically exit the programming

mode.

NOTE:

If safety devices are engaged then the display will show flashing «Er» (Error). Remove the cause of the error and repeat

learning.

2.3. ADVANCED PROGRAMMING

To perform advanced programming do the following:

1. Press and hold the «P» button for 10 seconds to enter the advanced programming. The left part of the display will show

«0», and the right part will show the menu item (see the Advanced Programming table).

2. Pressing the «+» or «-» buttons select the required menu item.

3. Press the «P» button to enter the menu item, the value of the adjusted parameter will start flashing on the display.

4. Pressing the «+» or «-» buttons change the value of the selected item.

5. Press the «P» button to save new value and exit to the main menu.

6. Having adjusted all the required parameters press «R» to exit the programming menu.

NOTE:

If you need to exit to the main menu without saving the parameters press «R».

Menu Item Function

0.0

Pass door or single-leaf gate automation mode: Y — enabled; n — disabled

0.1

Force on the 1st leaf: 1 — minimum force; 6 — maximum force

0.2

Force on the 2nd leaf: 1 — minimum force; 6 — maximum force

0.3

Maximum force at the start: Y — enabled; n — disabled

0.4

Pre-activation of signal lamp (5 sec): Y — enabled; n — disabled

0.5

Operation logics of the electric lock terminals (19–21): Y — electromagnetic; n — electromechanical

Closing safety devices activation:

0.6

Y — reverse movement after the gate opening is freed of obstruction; n — immediate reverse movement

Automatic gate closing after activation of photocells:

0.7

Y — enabled; n — disabled

Gate opening/closing with buttons held pressed (faulty remote control):

0.8

Y — enabled; n — disabled

Prohibition of the control commands acceptance during gate opening:

0.9

Y — enabled; n — disabled

Separate control logics:

S-B-S button — gate opening and stopping;

1.0

PED button — gate closing and stopping;

Y — enabled; n — disabled

1st leaf opening time with PED button:

1.1

0 — disabled; 1 — 3 sec; 2 — 4 sec; 3 — 5 sec; 4 — 8 sec; 5 — 15 sec; 6 — 20 sec; 7 — 25 sec; 8 — 30 sec; 9 — 40 sec

Remote programming:

1.2

Y — enabled; n — disabled

9.8

Reset to factory settings

9.9

Software version

OPERATOR PROGRAMMING

Default