DAC DA-113/HF Podręcznik użytkownika - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Akcesoria telefoniczne DAC DA-113/HF. DAC DA-113/HF 2 stron. Digital dictate station
Również dla DAC DA-113/HF: Skrócona instrukcja obsługi (2 strony)

Drukuj stronę

Setup

1. Using the telephone line cord supplied, plug one end into the unit's Data

jack (located on the rear), and the other end into the system or phone jack.

2. Connect the power adapter to the A/C jack on the unit's left side.

3. Lift the dialer directory card and plastic off the top. Remove the plastic tab

from underneath. This activates the internal battery for dialer memory.

4. Plug the foot control into the round jack on the back of the unit.

5. Turn DIP Switch 2 (in cluster of two) on. DIP Switch 1 (in cluster of two) on

to increase record sensitivity. If using a boom microphone turn this off.

Auto-Log

One-touch dialer #10 (bottom right) is used for the Auto-Log feature. If DIP

switch #4 is on, whatever is programmed to this dialer will automatically be

dialed. This could be a phone number or perhaps user ID.

DIP Switches

On the bottom of the unit there are six DIP switches - a group of two and a

group of four. To see the group of four, you must slide the plastic cover down.

There are four additional DIP switches located underneath the dialer directory

card on the top of the unit; these are not used. The functions for the bottom six

are listed below.

DIP Switch 1: Not used.

DIP Switch 2: On=Enables Record Latch (REC button toggles).

DIP Switch 3: On=Enables Record Insert (for DVI units only).

DIP Switch 4: On=Enables Auto-Log for dialer #10.

DIP Switch 1: On=Increased record sensitivity.

DIP Switch 2: On=Enables built-in microphone & microphone jack.

Flash

On the back of the unit is a switch labeled FLASH. There are three options:

600, 300, or 100. Always leave it to 600 or you may have issues with the

DISCONNECT function.

Programming Dialers

Before proceeding, verify that you have followed Setup steps 1-3 and that DIP

swith 4 is off.

1. Press Log On and then connect to your system (this may require entering a

user ID and even dialing a telephone number).

2. Press Store.

3. Dial the number(s) you wish to have stored.

4. Press the one-touch dialer you desire to program.

Repeat steps 2-4 for additional dialers.

Emulation

There are 5 different emulations for this model. The emulation determines

what processor your unit has and thereby what digits are sent with certain

functions.

C-Phone will have -C at the end of the model (DA-113/HF-C).

DVI will have -D at the end of the model (DA-113/HF-D).

Lanier will have -L at the end of the model (DA-113/HF-L).

Winscribe will have -W at the end of the model (DA-113/HF-W).

Voice Solutions will have -S at the end of the model (DA-113/HF-S).

Name

Processor Record Rewind Play

C-Phone

M123D

DVI

M123B

Lanier

M124M

Winscribe

M124W

Voice Solutions M124B

NOTE: You can see the processor version on a sticker located beneath DIP

switch 4, on the bottom of the unit. To see it, you must slide the plastic cover

down.

Stop

New

Job

* *