Canon PIXMA MX350 Uproszczona instrukcja serwisowa - Strona 5

Przeglądaj online lub pobierz pdf Uproszczona instrukcja serwisowa dla Wszystko w jednej drukarce Canon PIXMA MX350. Canon PIXMA MX350 35 stron. Cartridge reset
Również dla Canon PIXMA MX350: Instrukcja instalacji (17 strony), Instrukcja instalacji (11 strony), Instrukcja konfiguracji sieci (34 strony), Instrukcja konfiguracji sieci (16 strony), Broszura (2 strony), Instrukcja instalacji sieciowej (24 strony), Instrukcja instalacji sieciowej (17 strony), Podręcznik (4 strony)

Drukuj stronę
Canon PIXMA MX350 Uproszczona instrukcja serwisowa
Error
Error
code
No ink (no raw
[1688] U163 Ink has run out.
ink).
Warning: The ink
[1700] --- The ink absorber is
absorber
becomes almost
full.
The connected
[2001] --- Incompatible device
digital camera or
digital video
camera does not
support Camera
Direct Printing.
Non-supported
[2002] --- An unsupported USB
hub
Paper jam in the
[2801] --- Document in ADF.
ADF
No paper in the
[2802] --- No document in ADF.
ADF
The paper in the
[2803] --- Document is too long.
ADF is too long.
U No. Message on the LCD
Replace the ink
cartridge.
almost full.
detected.
Remove the device.
hub is connected.
Remove the hub.
Redo operation after
checking document in
ADF and pressing
[OK].
Press [OK] and redo
operation after setting
document.
Press [OK] and redo
operation.
Solution
Replace the empty ink
cartridge(s). Printing with an
empty ink cartridge can
damage the printer.
To continue printing without
replacing the ink
cartridge(s), press the Stop
button for 5 sec. or longer to
disable the function to detect
the remaining ink amount.
After the operation, it is
recorded in the printer that
the function to detect the
remaining ink amount was
disabled.
Replace the ink absorber,
and reset its counter. (See
2-1, Service Mode.)
Pressing the STOP button
will exit the error, and enable
printing without replacing the
ink absorber. However,
when the ink absorber
becomes full, no further
printing can be performed
unless the applicable ink
absorber is replaced.
Remove the cable between
the camera and the printer.
Remove the applicable USB
hub from the PictBridge
(USB) connector.
Remove the jammed paper
from the ADF, press the OK
button, then perform the
operation again.
Press the OK button, set the
document in the ADF, and
perform the operation again.
Press the OK button, and
perform the operation again.
(4/37)
Parts that are likely to be
faulty
- Ink cartridge
- Logic board
- Ink absorber kit
- PictBridge harness
- Logic board
- PictBridge harness
- Logic board
- Document upper guide
unit
- Document upper guide
unit
- Document upper guide
unit