Cognex DataMan 8600 Verifier Series Podręcznik referencyjny - Strona 10
Przeglądaj online lub pobierz pdf Podręcznik referencyjny dla Czytnik kodów kreskowych Cognex DataMan 8600 Verifier Series. Cognex DataMan 8600 Verifier Series 14 stron.
Drukuj stronę
Code Quality
Verification
In order to perform Direct Part Mark Verification, your reader must be calibrated as described in the previous section. To
read symbols and view verification results, perform the following steps:
1. Start the DataMan Setup Tool and connect to your reader.
2. Navigate to Settings > Code Quality.
3. Under the Verification Settings tab, check Verification Enabled.
4. Select the Results Display task pane by clicking Code Quality under View).
5. Place the verifier against the symbol and squeeze the trigger. The symbol must be centered within the field of
view, and the reader must be perpendicular to the surface containing the symbol and at the correct rotation. If the
reader is out of position, the DataMan Setup Tool displays this guide:
The verifier stand-off must be used to ensure correct symbol presentation and lighting requirements for the AIM-
DPM / ISO/IEC TR 29158 Quality Guideline.
6. Move the reader until the center of the
indicate that the symbol has been read and verified.
Formatting Output Data
Use the Data Formatting task pane of the DataMan Setup Tool to construct a customized output string each time you
read and verify a symbol. This allows the verifier to return Code Quality results when connected to a third-party
application instead of the DataMan Setup Tool.
red
rectangle lies within the
10
green
target rectangle. The reader beeps to
Code Quality