AmerTac Zenith ZB210 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Pilot zdalnego sterowania AmerTac Zenith ZB210. AmerTac Zenith ZB210 17 stron. Amertac zb210 universal remote control owner’s manual

Drukuj stronę

Setup

Battery Installation

1. On the back of the remote, push down on the tab

and lift the cover off.

2. Match the batteries to the + and - marks inside the

battery case, then insert 2 AAA Alkaline batteries.

3. Press the battery cover back into place.

Battery Saver

Your remote automatically turns off if the buttons are

depressed more than 30 seconds.

Code Saver

You will have up to 10 minutes to change the batteries

in your remote without losing codes you have

programmed. However, do not press any buttons until

batteries are installed in the remote. If buttons are

pressed without batteries in the remote, all codes will be

lost.

Direct Code Entry

NOTE: You can store any kind of code under any mode

(except TV). I.E. you can store a TV code under the CBL

button, or a TV code under the SAT button, etc.

However, you can only store TV codes under the TV

button.

1. Press and hold the SETUP button until the red

indicator stays on, then release the SETUP button.

2. Press and release the desired mode button (TV,

SAT/CBL). The red indicator blinks, then stays lit.

3. Enter the 4 digit code from the code tables (on

separate sheet). Note: after a valid code entry, the

red indicator turns off. For an invalid code, the red

indicator flashes.

4. With your device on, press CHANNEL UP. If the

device responds, no further programming is

required. Note: If some buttons do not operate your

equipment, try one of the other codes for your

brand.

Setup, cont.

Write your codes down here for easy reference later.

Type

Type stored

SAT/CBL

Code Search

If your product does not respond after you have tried all

the codes for your brand, or if your brand is not listed,

try searching for your code by following these steps.

1. Manually turn on the device (TV, SAT, CBL) to be

controlled.

2. Press and hold the SETUP button until the red

indicator stays on, then release the SETUP button.

3. Press and quickly release the desired mode button

(TV, SAT/CBL). The red indicator blinks off once.

4. Press the CHANNEL UP button repeatedly (up to

300 times) until the device to be controlled changes

channel. The red indicator blinks off with each

button press. If you accidentally overshoot the

code required, press the CHANNEL DOWN button

to backtrack through the library until the device

changes channel. Pressing CHANNEL UP changes

direction to forward again.

5. Press and release MUTE to install the code.

Most users will store satellite or cable codes under the

SAT/CBL button. If (for example) you want to store a TV

code under SAT/CBL, first follow the procedure for

Direct Code Entry (previous page) and press SAT/CBL

in step 2 of Direct Code Entry, then enter ANY TV code

in step 3 of Direct Code Entry. Then follow the steps

above for Code Search (or Brand Search, below).

Note: Code Search starts from the currently stored 4

digit number under that mode.

Code