Ames Instruments 64001 Instrukcja obsługi i instrukcje bezpieczeństwa - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instrukcje bezpieczeństwa dla Instrumenty analityczne Ames Instruments 64001. Ames Instruments 64001 8 stron. Laser distance meter
Drukuj stronę
Operating instructions
read the entire iMpOrtant SaFety inFOrMatiOn section
at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
General Operating instructions
powering Meter On and Off
1�
Press
to power Meter on�
Selecting units
c
Press
and
Selecting reference point
c
Press
to change laser reference point between front,
center, and rear of Meter�
auto power-Off
If Meter is not used for approximately 5 minutes, it will
automatically power off to preserve battery power�
Measurement Operation
Single Measurement Mode
1�
Press
to power Meter on�
Meter automatically enters
single measurement mode�
2�
Press
again to turn laser on�
Laser On Icon flashes on Display�
3�
Aim laser at target to be measured�
continuous Measurement Mode
1�
Press
to power Meter on�
2�
Hold
for a few seconds to begin
continuous measurement�
3�
Move laser between two points to be
measured and read measurement
from Display as it changes�
Page 6
at the same time to switch between measurement units�
For technical questions, please call 1-888-866-5797.
c
2�
Hold
to power Meter off�
4�
Press
again to begin measuring�
5�
Read measured distance on Display�
6�
Repeat steps to take additional
measurements� Up to two
previous measurements are
held on the Auxiliary Display
until Meter is powered off�
4�
Press
again to stop
measurement and turn laser off�
Item 64001