Flycam HD-5000 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria do kamer Flycam HD-5000. Flycam HD-5000 11 stron. Video stabilizer
Również dla Flycam HD-5000: Instrukcja obsługi (16 strony), Instrukcja montażu (10 strony)

Drukuj stronę

FLYCAM HD HA NDHELD VIDEO STABILIZER

B A L A N C I N G T H E H O R I Z O N T A L A X I S

When your Flycam HD Hand held video stabilizer is properly assembled, you can start the test

and setup of the horizontal balance. Horizontal balance allows the camera to remain level

during operation with the Central Post in a vertical position unless off axis framing is desired.

When testing for horizontal balance start from a flat and level surface like a table. This will allow

Flycam HD Hand held video stabilizer to hang freely as you hold it. If your Flycam HD Handheld

video Stabilizer is correctly balanced on its horizontal axis, then it will be both level & upright,

with the Central Post in a perfect vertical position.

Warning: If you do not have enough weight on the Base Platform the entire FLYCAM could flip

upside down. Should this movement start to happen be ready to catch the stalk before a

complete 180 degree occurs. This type of unwanted movement requires more weight to be

added to the base with additional weight discs.

Another way to accomplish horizontal balance is to move the center of gravity of the camera by

re-bolting the camera to a different area of the Head and Bottom Plate, either front to back or

side to side.

Should Flycam HD Handheld video stabilizer be front heavy, loosen the screws on the sides of the

Head Plate and gently slide Head Plate back until optimum balance is achieved.

Tilting to the back means the load is tail heavy requiring the plate to be adjusted forward on the

head.

Always secure the screws after any adjustments.

If you cannot achieve front to back axis balance with this method, then try remounting your

camera to a different hole on Head Plate. Having achieved horizontal balance for the front to

back axis, tighten the screws on the Head Plate.

If the Flycam HD Hand held video stabilizer leans to the right, then loosen screws on the bottom

of Bottom Plate and then gently slide the bottom Plate to left. If it leans to the left from the

operator's point of view, then adjust the bottom Plate to the right. A bit at a time until balance is

achieved.

Secure all screws after adjustments are made.

It may be necessary to reconfigure front to back adjustments once correct side-to-side

fine-tuning has been accomplished.

Another option to consider is moving the Counter Weight discs back & forth on the Base

Platform by sliding them either closer to or further away from the Center Post via the built in

base slots. Make sure to tighten the discs down should you move them.