Flycam FLCM-DN-ABQ Instrukcja montażu - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Profesjonalne akcesoria wideo Flycam FLCM-DN-ABQ. Flycam FLCM-DN-ABQ 12 stron. Dslr nano handheld camera stabilizer brace support
Drukuj stronęSlightly bottom heavy, it will be both stable and easier to control.
•
Make sure that everything is tight and position yourself behind the stand.
•
Grasp the center post near the base and move the center post from vertical to horizontal.
•
Hold it there. Be sure that it will not hit the stand when you drop the center post and put your free hand
to catch the center post when it drops.
•
Count how many seconds it will take to fall to vertical. Try using a stopwatch.
•
If the drop time is less then 2 seconds, it is too bottom heavy. You need to move the bottom mass closer
to the post.
•
If the drop time is more than two seconds, it is top heavy.
A drop Time of 2 - 2.5 Seconds is preferred.
NOTE: Recheck the balance by looking at the sled. If necessary, use the side screws and the bottom plate
screws to make required adjustments.
Balancing Review
Proper system balance can only be achieved once your camera is set up with the appropriate accessories
ready for shooting. This means batteries, lenses, media cards, LCD viewfinder/ monitor, quick release plate,
on-cam lights, and all the gear you will use for your recording session.
•
Remove the top plate of the Flycam and line up your camera so that its center of gravity is as close to the
center of the plate as possible (basically hold the camera in your hand until it feels balanced both left and
right as well as forward and back).
•
Find the hole in the plate that is as close to the threaded tripod mount on your camera as possible (while
you are still holding your camera's center of gravity to the center of the plate). Attach your camera (or
quick release mount if you have one). Tighten it down so it.
Check the vertical balance by using this drop time test
9