Canon 4400F - CanoScan - Flatbed Scanner Skrócona instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Skaner Canon 4400F - CanoScan - Flatbed Scanner. Canon 4400F - CanoScan - Flatbed Scanner 12 stron. Canon canoscan 4400f: quick start
Również dla Canon 4400F - CanoScan - Flatbed Scanner: Skrócona instrukcja obsługi (21 strony)
Drukuj stronę
4
Insert the film into
the Film Guide.
Place the film face
down with the frames
in reverse order.
• Use a blower brush to remove any dust from the film, which will affect the image
quality, and take care to hold the film by its edges to avoid transferring dirt or
fingerprints to it.
• Do not block the calibration slot on the Film Guide when scanning film. Colors will not
be scanned correctly if the calibration slot is obstructed.
• Close the Film Guide securely. Press lightly until it clicks into place.
How to Use the Shield
When scanning short or curled film, extra light
may enter through gaps and produce bands of
color around the edges of the scanned image. If
this occurs, use the supplied shield as shown in
the figure.
5
Set the Film Guide to the
document cover, and
close the document
cover.
Hold the document cover and
insert the bottom edge of
the Film Guide into the
bottom groove in the
document cover, and then
tilt the top of the Film Guide
up into the document cover
until it locks securely into
place with a click.
Scanning Film
7